Whirlpool ET14JK warranty Using your refrigerator, Setting the Controls

Using your refrigerator

Refrigeiator Control- set On 3 Power Saving Control LightSwitch Freezer Control- Set on B

Setting the Controls.

The Refrigerator and Freezer Controls are on a console Inside the refrigerator at the top. To start the refrigerator, set the Refrigerator Control to 3 and the Freezer Control to B.

When you first turn it on, it will run continuously until the insides are properly cold. It takes time for your refrigerator and freezer to get cold enough to store food safely. Before loading it with food, be sure the refrigerator motor has cycled at least once (turned on, turned off, and turned on again]. This may take up to a day.

The following chart gives recommended control settings for a number of operating conditions.

OPERATING										RECOMMENDED
CONDITIONS										CONTROL	SETTINGS
For Normal		Use.
-	Normal		number				of door		openings.	Refrigerator	3
-	Normal		amounts				of food		added	Freezer..	B
-	Normal		room			temperature.
If Refrigerator				Section is Too Warm:
-Door		opened				often				Refrigerator	4
-	Large,	warm food					load	added.		Freezer	C
- Room temperature very warm.
If Freezer Section is Too Warm:
-Door		opened				often.				Refrigerator	3
-Large		amount				of warm		food added		Freezer	A
-Very cold room temperature.
If Ice isn’t Made Fast Enough:
-	Heavy	ice		usage.						Refrigerator	3
-	Cold	room			temperature.					Freezer	A
If Both Sections are Too Warm:
-	Doors	opened				often.				Refrigerator	4
-Large		amounts				of food		added.		Freezer	B
-Very warm					or cold room				temperatures.
			---.
POWER SAVING CONTROL: It’s normal for
moisture to form around the doors when
room	humidity			is high
-	If morsture			forms						REDUCES EXTERIOR
- If no moisture forms...room humidity is										MOISTURE
low or during			heating				season.			CONSUMES	LESS
										ENERGY

The temperature setting will be about right when milk or juice are as cold as you like. If you need to adjust the settings to match the way your refrigerator is used, use the settings suggested in the chart above. Chonge only one control of o lime. Wait o day, then make onother

change, If needed