3.Select cycle and wash time Start the washer
lPush in the Cycle Control Knob and turn it clockwise.
lStop when the indicator on the knob’s outer ring points to the number in the wash cycle you want. The numbers are minutes of wash time.
lStart the washer by pulling out the Cycle Control Knob. The washer will fill to the selected water level with the selected wash water temperature. After filling, the washer will agitate for the selected number of minutes.
lTo stop the washer at any time, push in the Cycle Control Knob. To restart the washer, pull out the Cycle Control Knob.
What happensin each cycle
Each cycle has been designed for dif- ferent kinds of fabrics. Numbers on the dial in each cycle are the minutes of wash agitation time.
When the Cycle Control Knob is set to a number and pulled out, the washer fills before agitation and timing starts.
After agitation starts, the knob turns clockwise until it points to OFF and the cycle ends.
The washer will pause briefly through- out each cycle. These pauses are normal. They allow for the reversing
of the motor, normal washer operation and the
NOTE: You may hear the sound of water spraying during the spin parts of some cycles. In some cycles, water is sprayed on the spinning load to help with the rinsing.
5