Whirlpool GC5SHGXKB00 manual Water Supply Connection, Cold Water Supply, Connecting to Water Line

Page 6

3.Open the freezer door and turn on the ice maker by lowering the wire shutoff arm. Please refer to the “Ice Maker and Storage Bin/Bucket” section for further instructions on the operation of your ice maker.

■Allow 24 hours to produce the first batch of ice.

■Discard the first three batches of ice produced.

Water Supply Connection

Read all directions carefully before you begin.

IMPORTANT:

■If you turn the refrigerator on before the water line is connected, turn the ice maker OFF.

■All installations must meet local plumbing code requirements.

■Use copper tubing and check for leaks. Install copper tubing only in areas where household temperatures will remain above freezing.

Tools required: Flat-blade screwdriver, ⁷⁄₁₆ in. and ¹⁄₂ in. open- end wrenches or two adjustable wrenches, ¹⁄₄ in. drill bit, hand drill or electric drill (properly grounded).

NOTE: Your refrigerator dealer has a kit available with a ¹⁄₄ in. (6.35 mm) saddle-type shutoff valve, a union, and copper tubing. Before purchasing, make sure a saddle-type valve complies with your local plumbing codes. Do not use a piercing-type or ³⁄₁₆ in. (4.76 mm) saddle valve which reduces water flow and clogs more easily.

Cold Water Supply

Connect the ice maker to a cold water line with water pressure between 30 and 120 psi. If you have questions about your water pressure, call your utility company.

Connecting to Water Line

1.Unplug refrigerator or disconnect power.

2.Turn OFF main water supply. Turn ON nearest faucet long enough to clear line of water.

3.Find a ¹⁄₂ in. (12.70 mm) to 1¹⁄₄ in. (3.18 cm) vertical COLD water pipe near the refrigerator.

NOTE: Horizontal pipe will work, but the following procedure

must be followed: Drill on the top side of the pipe, not the bottom. This will help keep water away from the drill. This also keeps normal sediment from collecting in the valve.

4.Route ¹⁄₄ in. (6.35 mm) copper tubing from the water pipe to the lower rear corner of the refrigerator location. Be sure both ends of copper tubing are cut square.

5.Using a grounded drill, drill a ¹⁄₄ in. (6.35 mm) hole in the cold water pipe you have selected.

1.

Cold Water Pipe

5.

Compression Sleeve

2.

Pipe Clamp

6.

Shutoff Valve

3.

Copper Tubing

7.

Packing Nut

4.

Compression Nut

 

 

6.Fasten shutoff valve to cold water pipe with pipe clamp. Be sure outlet end is solidly in the ¹⁄₄ in. (6.35 mm) drilled hole in the water pipe and that washer is under the pipe clamp. Tighten packing nut. Tighten the pipe clamp screws carefully and evenly so washer makes a watertight seal. Do not overtighten or you may crush the copper tubing, especially if soft (coiled) copper tubing is used. Now you are ready to connect the copper tubing.

7.Slip compression sleeve and compression nut on copper tubing as shown in the diagram. Insert the end of the tubing into the outlet end of the shutoff valve as far as it will go. Screw the compression nut onto the outlet end with an adjustable wrench. Do not overtighten.

8.Place the free end of the tubing into a container or sink, and turn ON main water supply and flush out tubing until water is clear. Turn OFF the shutoff valve on the water pipe.

Connecting to Refrigerator

1.Remove the shipping tape from the gray, coiled water tubing on the rear of the refrigerator.

2.Style 1: Thread the provided nut onto the coupling on the end of the copper tubing. Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten.

 

1

2

3

4

5

6

1.

Line to Refrigerator

 

4.

Coupling (purchased)

2.

Nut (provided)

 

5.

Ferrule (purchased)

3.

Bulb

 

 

6.

Nut (purchased)

Style 2: Thread the provided nut onto the water valve as shown.

1

2

1.Bulb

2.Nut (provided)

NOTE: Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten.

3.Turn shutoff valve ON.

4.Check for leaks. Tighten any nuts or connections (including connections at the valve) that leak.

5.Plug in refrigerator or reconnect power.

6.Flush the water system. See the “Water System Preparation” section.

NOTE: It may take up to 24 hours for your ice maker to begin producing ice.

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Use & Care Guide Cabinet Depth Side by Side RefrigeratorRéfrigérateur Côte À Côte À Profondeur ’ARMOIRE Guide d’utilisation Et d’entretienTable DES Matières Refrigerator Safety Before you throw away your old refrigerator or freezerUnpacking Installation InstructionsCleaning before use Location RequirementsWater System Preparation Electrical RequirementsRemoving the Door Handles On some modelsWater Supply Connection Connecting to Water LineConnecting to Refrigerator Cold Water SupplyInstalling Custom Wood Panels Custom Door PanelsCreating Custom Wood Panels Style To remove the base grille Leveling RefrigeratorBase Grille To replace the base grilleNormal Sounds Using the ControlsRefrigerator USE Ensuring Proper Air CirculationWater and Ice Dispensers Adjusting ControlsCONDITION/REASON Setting Adjustment Ice dispenserWater dispenser Water filter indicator lightWater Filtration System Dispenser lock on some modelsOn some models Accessory Ice Maker and Storage Bin/BucketMeat Drawer, Crisper and Covers Refrigerator FeaturesRefrigerator Shelves Meat storage guideFreezer Features Door Features Refrigerator CarePower Interruptions Changing the Light BulbsTroubleshooting Vacation and Moving CareOff-taste, odor or gray color in the ice Refrigerator seems to make too much noiseIce maker is not producing ice or not enough ice Ice dispenser will not operate properlyWater dispenser will not operate properly Temperature is too warmIce bucket difficult to remove Water or ice is leaking from the dispenserU.S.A Accessories Water Filter CertificationsCanada Performance Data Sheets Substance Reduction Min. Required %Application Guidelines/Water Supply Parameters ONE-YEAR Full Warranty Whirlpool Corporation will not pay forCall Sécurité DU Réfrigérateur Avant de jeter votre vieux réfrigérateur ou congélateurDéballage Instructions ’INSTALLATIONEmplacement d’installation Nettoyage avant l’utilisationEnlèvement des poignées des portes Méthode recommandée de mise à la terreSpécifications électriques Préparation du système d’eauRaccordement à une canalisation d’eau Raccordement de la canalisation d’eauArrivée d’eau froide RemarquesPanneaux de porte sur commande Création de panneaux de bois sur commandeRaccordement au réfrigérateur Style Pour enlever la grille de la base Installation des panneaux de bois sur commandeGrille de la base Pour replacer la grille de la baseNivellement du réfrigérateur Sons normauxUtilisation DU Réfrigérateur Utilisation des commandesRéglage des commandes électroniques Pour s’assurer d’une circulation d’air AppropriéeLe distributeur de glaçons Ajustement des commandesDistributeurs d’eau et de glaçons CONDITION/RAISON AjustementLe distributeur d’eau Système de filtration d’eauLumière du distributeur Verrouillage du distributeur sur certains modèlesRemplacement de la cartouche de filtre à eau Commande de filtres de remplacementUtilisation du distributeur sans filtre à eau Pour enlever et replacer le bac à glaçons Accessoire sur certains modèlesMise en marche/arrêt de la machine à glaçons Entretien du bac d’entreposage de glaçonsTablettes du réfrigérateur Tiroir àviande, bac àlégumes et couverclesPorte-cannettes/bouteilles ou casier à vin CongélateurTiroir à boisson Bac utilitaireTringles dans la porte PortePanier du congélateur Bac en plastique sur certains modèlesNettoyage Entretien DU RéfrigérateurCompartiments dans la porte Pour nettoyer le réfrigérateurLumière du tableau de commande Pannes de courantLumière de l’espace de distribution sur certains modèles Dépannage DéménagementLa machine à glaçons ne produit pas de glaçons ou trop peu Le moteur semble fonctionner excessivementLe réfrigérateur semble faire trop de bruit Mauvais goût, odeur ou couleur grise des glaçonsLe distributeur d’eau ne fonctionne pas bien Le distributeur de glaçons ne fonctionne pas correctementLe seau à glaçons est difficile à enlever ’eau ou la glace coule du distributeur’eau du distributeur n’est pas assez froide Solution de problèmes pour ordinateurs sur certains modèlesLe débit d’eau du distributeur diminue beaucoup La cloison entre les deux sections est tièdeAccessoires Feuilles DE Données SUR LE Produit Réduction de De réduction Substances Min. reqGarantie Complète DE UN AN Whirlpool Corporation ne paiera pas pour2221543 Whirlpool Corporation All rights reserved

GC5SHGXKB00 specifications

The Whirlpool GC5SHGXKB00 is a side-by-side refrigerator that combines modern design, reliability, and technology to enhance the user experience in any kitchen. This refrigerator is particularly known for its spacious layout and efficient organization, making it a favorite among families and culinary enthusiasts.

One of the standout features of the GC5SHGXKB00 is its generous storage capacity. With a total refrigerator volume of approximately 25 cubic feet, it provides ample space for all your food and beverage needs. The side-by-side design allows for easy access to both fresh and frozen items, with adjustable glass shelves that can be customized to accommodate taller items. The interior also boasts bins and drawers that are designed for optimal organization, keeping your kitchen essentials within easy reach.

The refrigerator utilizes advanced cooling technology to maintain the freshness of your food. Its Accu-Chill temperature management system is designed to monitor and adapt to internal temperatures, ensuring that your groceries remain at their ideal temperature without the hassle of manual adjustments. This system not only enhances food preservation but also contributes to energy efficiency, reducing overall power consumption.

Another notable characteristic of the GC5SHGXKB00 is its external water and ice dispenser. This feature allows for easy access to chilled water and ice, offering convenience for busy families. The filter used in the water system ensures that the water and ice produced are of high quality, enhancing the taste of your beverages. Additionally, the unit is designed with a sleek black finish that offers a modern aesthetic, adding elegance to your kitchen decor.

The Whirlpool GC5SHGXKB00 is also equipped with innovative features aimed at increasing user convenience. The interior LED lighting brightens every corner of the refrigerator, making it easy to find what you need, even in low-light conditions. The unit also operates quietly, allowing for a peaceful kitchen environment.

In summary, the Whirlpool GC5SHGXKB00 is a reliable and feature-rich side-by-side refrigerator that excels in storage capacity, advanced cooling technology, and user-centric design elements. Its combination of efficiency, convenience, and modern aesthetics makes it a valuable addition to any home. With its solid construction and thoughtful features, it is designed to meet the demands of everyday life while maintaining the highest standards of food preservation.
Top Page Image Contents