Whirlpool ETl8JM Adjusting the shelves, Removing crispers and crisper cover, Automatic ice maker

Adjusting the shelves...

I. First, remove food from shelf. 2. Slide shelf straight out to stop.

3. Lrft front.

4. Shde the rest of the way out.

Replacing Shelf:

Shelf Stop a

I.Frt back of shelf on top of guides wrth wire stops on the bottom of gurdes.

2.Lift front, slide shelf in until It clears guide stops.

Removing crispers and crisper cover.. .

Removing the Crispers: Lift the Front, Then the Back.

I, Slide crisper straight out to stop, III? front, then slide the rest of the way out

2. Replace in the reverse order.

Removing Cover:

I, Lift front and remove the cover support 2. Lift out cover by pulling up and out.

Replacing Cover:

I, Fit back of cover into notch supports on walls of refrigerator, then lower front into place.

2. Replace cover support with the long tab towards ,

the front. Note: If support needs adjustment, turnLift the Front!r?!j%rttl?~~~: base right to lower, or left to raise.

Changing the light bulb.. .

WARNING: Before removing the light bulb, either unplug the refrigerator or disconnect

the electricity leading to the re- frigerator at the main power supply. Shock and injury can occur if elec- tricity remains connected.

1. Reach behind control console to find bulb.

2. Remove bulb

3. Replace with a 40.watt appliance bulb

Automatic ice maker.. .

If you have the automatic ice maker accessory or plan to add one later (Part No. ECKMF-83), there are a few things you will want to know:

l The ON/OFF lever is a wire signal arm. Down,, .for making ice automatrcally; Up...toshut off the ice maker.

l Shake the bin occasionally to keep cubes sepa- rated, and to obtain increased storage capacity.

Lower	Sig;lal	\	Raise Signal
Arm	to Start It.		Arm to Stop Ice Maker.

l

l

l

l

l

l

l

l

It is normal for ice crescents to be attached by a corner. They will break apart easily.

You will hear water runnrng when ice maker is working, You’ll hear ice fall into the bin. Don’t let these sounds bother you.

The ice maker will not operate until the freezer IS cold enough to make ice, This con take overnight. Because of new plumbing connections, the first ice may be discolored or off-flavored. Discard the first few batches of ice.

If ice is not being made fast enough and more ice is needed, turn the Refrigerator Control toward a higher number. Wait a day and, if necessary, turn the Freezer Control toward A.

If you remove the Ice bin, raise the signal arm to shut off the ice maker. When you return the bin, push it all the way in and lower the arm to the ON position.

If cubes are stored too long, they may develop an off-flavor...like stale water. Throw them away. They will be replaced. Cubes in the ice bin can also become smaller by evaporation.

The ice maker water supply should not be soft- ened water. The chemicals could damage the ice maker molds.

6