Whirlpool GB2SHKXMQ00 manual BaseGrille, RefrigeratorDoors

Page 6

6.Fasten shutoff valve to cold water pipe with pipe clamp. Be sure outlet end is solidly in the ¹⁄₄" drilled hole in the water pipe and that rubber washer is under the pipe clamp. Tighten packing nut. Tighten the pipe clamp screws carefully and evenly so rubber washer makes a watertight seal. Do not overtighten or you may crush the copper tubing, especially if soft (coiled) copper tubing is used. Now you are ready to connect the copper tubing.

7.Slip compression sleeve and compression nut on copper tubing as shown. Insert end of tubing into outlet end squarely as far as it will go. Screw compression nut onto outlet end with adjustable wrench. Do not overtighten.

8.Place the free end of the tubing into a bucket or sink. Turn ON main water supply and flush out tubing until water is clear. Turn OFF shutoff valve on the water pipe. Check for leaks. Coil copper tubing.

Connect to Refrigerator

1.Remove plastic cap from water valve inlet port. Attach the copper tube to the valve inlet using a compression nut and sleeve as shown. Tighten the compression nut. Do not overtighten. Confirm copper tubing is secure by pulling on copper tubing.

2.Create a service loop using extreme care to avoid kinks. Secure copper tubing to refrigerator cabinet with a “P” clamp.

A

B

C

D

E

A. Copper Tubing

D. Compression Sleeve

B. “P” Clamp

E. Water Valve Inlet Port

C. Compression nut

 

3.Turn on water supply to refrigerator and check for leaks. Correct any leaks.

4.Plug in refrigerator or reconnect power.

5.Push refrigerator into opening.

BaseGrille

Remove Base Grille

1.Open the freezer door.

2.Grasp the grille with both hands.

3.Pull up on the bottom and tilt it toward you.

4.Pull down to release the top of grille.

Replace the Base Grille

1.Open the freezer door.

2.See markings on inside of base grille for proper placement.

3.Snap the top of grille into place first.

4.Press down and in on the bottom of the grille until it snaps into place.

RefrigeratorDoors

Install and Remove Handle

Graphics are included later in this section.

1.Place handle on door as shown.

2.Using a Phillips screwdriver, attach handle to door with handle screws.

3.Place the trim pieces on the upper and lower handle ends as shown.

4.Apply firm pressure with your hand on the face of the trim. Slide the top trim down and bottom trim up toward the handle.

5.Using a Phillips screwdriver, attach the freezer handle to the freezer door with the two screws provided.

6.To remove handles, reverse directions.

6

Image 6
Contents BOTTOM-MOUNT Refrigerator Table of Contents Refrigerator Safety Before You Throw Away Your Old Refrigerator or FreezerUnpacktheRefrigerator Installation InstructionsClean Before Using LocationRequirementsElectrical Requirements Water Supply RequirementsConnecttheWaterSupply BaseGrille RefrigeratorDoorsReplace Doors and Hinges Remove Doors and HingesReverse Doors optional on some models Final StepsDoor Removal Replacement NormalSounds AdjusttheDoorsRefrigerator USE EnsuringProperAirCirculationIceMaker UsingtheControlsAdjusting Controls Turning the Ice Maker On/OffRefrigerator Features RefrigeratorShelvesMeatDrawerandCover Freezer Features Door Features Refrigerator CareChanging the Refrigerator Light Bulb PowerInterruptionsChangingtheLightBulb Changing the Freezer Light BulbTroubleshooting VacationandMovingCareIce maker is not producing ice on some models Temperature is too warmRefrigerator seems to make too much noise Ice maker is producing too little ice on some modelsInCanada Assistance or ServiceAccessories TheU.S.AWhirlpool Refrigerator Warranty Whirlpool Corporation will not pay forCall Sécurité DU Réfrigérateur Avant de jeter votre vieux réfrigérateur ou congélateurDéballagedu réfrigérateur Instructions D’INSTALLATIONEmplacementd’installation Enlèvement des matériaux d’emballageSpécificationsélectriques Spécifications del’alimentationen eauRaccordementdelacanalisation deau Pour enlever la grille de la base GrilledelabaseRaccordement au réfrigérateur Pour replacer la grille de la basePortes du réfrigérateur Installation et enlèvement des poignées de porteRéinstallation Portes et charnières Enlèvement des portes et des charnièresÉtapes finales Inspecter tous les trous. Vérifier que tous les bouchonsAjustementdesportes SonsnormauxFermeture des portes Utilisation DU Réfrigérateur Utilisationdes commandesAjustement des réglages de commande Réglage moyenCaractéristiques DU Réfrigérateur MachineàglaçonsTablettes duréfrigérateur Bac àlégumes etcouvercle TiroiràviandeetcouvercleRéglagedel’humiditédans lesbacs àlégumes Congélateur LA Porte Entretien DU RéfrigérateurRemplacement de lampoule du compartiment de congélation Remplacementdel’ampouled’éclairageRemplacement de lampoule du compartiment de réfrigération Pannes decourantDéménagement DépannageEntretien avantlesvacancesou lors ’un déménagement Les ampoules n’éclairent pasLa cloison entre les deux sections est tiède Le moteur semble fonctionner excessivementLe réfrigérateur semble faire trop de bruit La température est trop tièdeAssistance OU Service AccessoiresGarantie DU Réfrigérateur Whirlpool Whirlpool Corporation ne paiera pas pour12828108/2300234 Whirlpool Corporation All rights reserved

GB2SHKXMQ00 specifications

The Whirlpool GB2SHKXMQ00 stands out as a modern refrigerator, engineered to meet the demands of contemporary households. With a combination of innovative features and advanced technologies, it offers a seamless user experience while ensuring food preservation and energy efficiency.

One of the standout characteristics of the GB2SHKXMQ00 is its capacity. With ample storage space, it caters to families of different sizes, accommodating everything from large pizza boxes to tall bottles. The well-designed interior optimizes space, featuring adjustable shelves that allow users to customize the layout according to their needs. The exterior boasts a sleek stainless steel finish, giving it a stylish look that can complement any kitchen decor.

The refrigerator employs Whirlpool's precise temperature management technology, which utilizes an adaptive cooling system to maintain consistent temperatures across all compartments. This ensures that food items are kept fresh while extending their shelf life. The advanced cooling system also minimizes temperature fluctuations, which can be detrimental to perishable items.

In terms of organization, the GB2SHKXMQ00 is equipped with innovative storage solutions. It features humidity-controlled crispers designed to keep fruits and vegetables fresher for longer. Additionally, the door bins are specifically designed for easy access to frequently used items such as condiments and beverages, enhancing convenience for the user.

Energy efficiency is a crucial aspect of the Whirlpool GB2SHKXMQ00. The appliance is ENERGY STAR certified, meaning it consumes less power than standard models while providing optimal performance. The energy-saving features not only reduce electricity bills but also minimize environmental impact, making it a responsible choice for eco-conscious consumers.

Whirlpool's unique FreshFlow technology plays a significant role in preserving the quality of food. This system includes an air filter and an ethylene gas filter that work together to keep the refrigerator's atmosphere fresh and free from unpleasant odors. This ensures that food retains its original flavor and freshness for an extended period.

For added convenience, the GB2SHKXMQ00 incorporates easy-to-use controls, allowing users to adjust settings with minimal effort. Its integrated ice maker ensures that there’s always ice on hand, perfect for entertaining guests or enjoying a refreshing drink.

In summary, the Whirlpool GB2SHKXMQ00 is a feature-rich refrigerator designed for modern living. Its focus on space optimization, advanced cooling technologies, and energy-efficient operation make it a valuable addition to any kitchen. With its combination of functionality and style, it is the perfect choice for those seeking reliability and performance in their kitchen appliances.