Whirlpool ETl4EP manual Install Properly Remove sales labels, Level refrigerator-freezer, Clean it

Install	properly..	Remove sales labels.. .
		Remove the Consumer Buy Guide label, tape and
		any lnslde labels before using the refrigerator.
		To remove any remaining glue:
		I, Rub briskly with thumb to make a ball then remove.
		OR
		2. Soak area with dishwashing detergent solution (1
		teaspoon detergent	in 1 quart warm	water] before
		removing glue as described in step 1.
		DO NOT USErubbing alcohol or flammable or
		toxic solvents, such as acetone, gasoline, car-
		bon tetrachlortde,	etc. These can	damage the
		material.

NOTE: DO NOT REMOVE ANY PERMANENT IN-

STRUCTION LABELS INSIDE YOUR REFRIGERATOR.

Do not remove the Tech Sheet fastened under

the retrigemtor	at the front.	/ j..Il,lT..rI.>. j	,l. _‘1
~’‘I.es’‘C

1.Allow 3 inches (7.5 cm] between overhead cabi- nets and refrigerator top.

2.Allow at least an inch (2.5 cm) between the refrigerator condenser on the back and the wall.

3.Allow % inch (1.25 cm] on each side of the refrigerator for ease of installation.

4.If the refrigerator is to be against a wall, you might want to leave extra space on the hinge side so the door can be opened wider

‘ :t-- , i8fi,.:-3wswmm ? 411 L3

Level refrigerator-freezer.. .

1.Adjust each leg until the refrigerator won’t rock.

2.Slide the refrigerator into place.

3.Adjust front legs to level the refrigerator.

-To raise corners, turn legs clockwise.

-To lower corners, turn legs counterclockwise,

4.Check with level.

Clean it...

Clean your refrigerator before using it.

See cleaning instructions on page 8.

j-prong grounding type wall receptacle,

Refrigerator

Power Cord

RECOMMENDEDGROUNDING METHOD

A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused

and properly grounded electrical supply is re-

quired. It is recommended that a separate circuit serving only this appliance be provided.

Do not use an extension cord. Use a recep- tacle which cannot be turned off wlth a switch or pull chain. See individual electrical require- ments and grounding instruction sheet in your liter- ature package.