Install properly...
IN-
III
a
1.Allow 3 inches (7.5 cm] between overhead cab- inets and refrigerator top.
2.Allow at least an inch (2.5 cm) between the re- frigerator condenser on the back and the wall.
3.Allow YZinch (1.25 cm) on each side of the re- frigerator for ease of installation.
4.If the refrigerator is to be against a wall, you might want to leave extra space on the hinge side so the door can be opened wider.
Level refrigerator-freezer.. .
USE SCREWDRIVER
TO ADJUST |
|
LEVELLING SCREW | II |
RAISE h |
1.To raise front, turn each screw to the right
2.To lower front, turn each screw to the left.
3.Check with level.
Remove sales labels...
Remove the Consumer Buy Guide label, tape and any lnslde labels before using the re- frigerator. To remove any remalnlng glue:
1.Rub briskly with thumb to make a ball then remove.
OR
2.Soak area with liquid hand dishwashing detergent before removing glue as described in step 1.
DO NOT USErubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car- bon tetrachlorlde, etc. These can damage the materlal.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTIONS LABELS INSIDE YOUR REFRIGER- ATOR.
Do not remove the Tech sheet fastened under the retrlgerator at the tront.
Clean it...
Clean | your | refriger- | |
ator | before using it. | ||
See | cleaning | instruc- | |
tions | on | page8. | , |
Plug it in...
| J | |
REFRIGERATOR | ||
GROUNDING PLUG | ||
POWER CORD |
RECOMMENDED GROUNDING METHOD
A 115Volt, 60 Hz.,AC only 15 or 20 ampere fused and properly grounded electrical supply is required. It is recommended that a separate cir- cuit serving only this appliance be provided.
Do not use an extension cord. Use a recepta- cle which cannot be turned ott wlth a swttch or pull chain. See individual electrical requirements and grounding instruction sheet in your literature package.
4