Section 4: Specifications
Power amplifier management
Power amplifier interface
Compatibility | QSC Data Port equipped amplifiers |
Connector and cable |
|
| |
| qualified (for longer runs, contact |
| QSC’s Technical Services Department) |
|
|
Amplifiers | Up to eight |
| amplifiers ( or some combination thereof) |
| |
Amplifier status monitor | |
Clip indicator | Senses channel clipping |
Protect indicator | Senses amplifier protect status |
Temperature meter | Reports amplifier operating |
| temperature |
Software adjustable threshold | |
|
|
AC power control |
|
AC mode control | Switches amplifier between |
| normal and standby mode |
AC power indicator | Indicates operate, standby, or |
|
Control room foldback monitoring
Signal monitoring buses | 1 |
(per CM16) |
|
|
|
Number of Channels | 4 |
|
|
Internal signal tap points |
|
16 | |
16 | |
Power amplifier output | 16 |
|
|
Monitor input | Mixed with tap point signal at |
| unity gain |
Nominal level | +4 dBu |
Maximum level | +21 dBu |
Input impedance | 10 kOhm balanced |
Configuration | Electronically balanced, shield |
| connected to chassis |
Typical, >50 dB, 20 Hz - 20 kHz | |
| Worst case, >40 dB, 20 |
Output | Sum of Monitor input and |
| signal from internal monitor |
| tap point |
Frequency response | 25 |
Distortion | <0.05% THD @ +4 dBu out |
Noise floor | |
Nominal level | +4 dBu |
Maximum level | +21 dBu |
Output impedance | 75 Ohms balanced |
Output load | 600 Ohms minimum |
Configuration | Active balanced |
|
|
Level | Adjusts amplitude of signal from |
| tap point |
Monitor in to monitor out | 0 dB, ±0.5 dB |
Control range |
Contact closure inputs and outputs
Inputs | 1 discrete input |
Configuration | |
Resistance for closure detect <1kOhm max | |
Resistance for open detect | >5 kOhm min |
Input Voltage Limit | 7.000 VDC maximum |
Output |
| 1 discrete output |
Configuration |
| Electromechanical relay, dry |
|
| contacts, floating, C, NC, NO |
0.5 A | ||
Switched current (max.) | 0.25 A | |
Ground isolation |
| 70 volts maximum |
|
| |
Connector | ||
| detachable terminal block connectors |
34