Whirlpool AKT464 Pratical Advice for Using the Burners, HOW to USE the HOB

PRATICAL ADVICE FOR USING THE BURNERS

This hob has burners of different diameters. For better burner performance, please stick to the following rules:

-Use pots and pans with bottoms the same width as that of the burners or slightly larger (see table on the right).

-Only use flat-bottomed pots and pans.

-Use the correct amount of water for cooking foods and keep the pot covered.

-Make sure pots on the grates do not protrude beyond the edge of the hob.

IMPORTANT: improper use of the grids can result in damage to the hob: do not position the grids upside down or slide them across the hob.

Do not use:

-Cast iron griddles, ollar stones, terracotta pots and pans.

-Heat diffusers such as metal mesh, or any other types.

-Two burners simultaneously for one receptacle (e.g. fish kettle).

HOW TO USE THE HOB

Burner	Pot Ø
Ultra-rapid	From 24 to 26 cm
Semi-rapid	From 16 to 22 cm
Auxiliary	From 8 to 14 cm

INJECTORS TABLE								CATEGORY II2H3B/P
Type of gas used		Type of burner	Injector		Rated thermal	Rated	Reduced heat		Gas pressure
			marking		flow rate	consumption		capacity		mbar
					kW			kW	min.	rat.	max.
NATURAL GAS		Ultra-rapid	144B		3.50	333 l/h		0.60
		Semi-rapid	97		1.65	157 l/h		0.35	17	20	25
(Methane)	G20
		Auxiliary	74B		1.00	95 l/h		0.30
LIQUEFIED		Ultra-rapid	94		3.50	254 g/h		0.60
PETROLEUM GAS		Semi-rapid	65		1.65	120 g/h		0.35	25	30	35
(Butane)	G30
		Auxiliary	50		1.00	73 g/h		0.30
(Propane)	G31
Type of gas used		Model		Rated thermal		Total rated		Air required (m3) for
		configuration		flow rate (kW)		consumption		burning 1 m3 of gas
G20 20 mbar		4 burners			7.80	742 l/h			9.52

WARNING Do not let the burner flame extend beyond the edge of the pan.

IMPORTANT: WHEN THE HOB IS IN USE, THE ENTIRE HOB AREA MAY BECOME HOT.

•To ignite one of the burners, turn the relative knob anti-clockwise to the maximum flame setting.

•Press the knob against the control panel to ignite the burner.

•After the burner has ignited, keep the knob pressed for about 5-10 seconds to allow proper device operation.

This burner safety device shuts off the gas supply to the burner if the flame goes out accidentally (because of sudden draught, an interruption in the gas delivery, boiling over of liquids, etc.).

•The knob must not be pressed for more than 15 sec. If, after that time has elapsed, the burner does not remain lit, wait at least one minute before trying to light it again.

NOTE: should particular local conditions of the delivered gas make the ignition of burner difficult, it is advisable to repeat

the operation with the knob turned to small flame setting.

The burner might go out when the knob is released. This means that the safety device has not warmed up enough. In this case, repeat the operations described above.

DIMENSIONS AND DISTANCES TO BE MANTAINED (mm)

NOTE: if the distance “A” between the wall cabinets is between 600 mm and 730 mm, the height “B” must be a minimum of 530 mm.

If the distance “A” between the wall cabinets is greater than the width of the cooktop, the height “B” must be a minimum of 400 mm.

In case of installation of a hood above the cooktop, please refer to the hood instructions for the correct distance.

G30/G31 30 mbar 4 burners 7.80 567g/h 30.94

ELECTRIC SUPPLY: 230 V ~ 50 Hz