When cleaning the cooktop area or around the burner base, use care to prevent damage to the ignitor. If a sponge should catch the metal ignitor electrode, it could damage or break the electrode. If the electrode is damaged or broken, the surface burner will not light. When cleaning the cooktop, leave the burner cap in place to protect the elec- trode from possible damage.
Surface | burners |
|
|
l The burner | caps should be routinely | Locating | Burner |
removed and cleaned. Always clean burner |
|
| |
caps after a spillover. Keeping the burner |
|
| |
caps clean prevents improper ignition and |
|
| |
an uneven | flame. |
|
|
l For proper flow of gas and ignition of the burner, DO NOT ALLOW SPILLS, FOOD,
CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS TUBE OPENING.
l Gas must flow freely through the small hole in the brass orifEe for the burner to light properly. This area must be free of any soil and be kept protected from boilovers or spillovers. ALWAYS keep the burner caps in place whenever a surface burner is in use.
l Occasionally check the burner flames for proper size and shape as shown. A good flame is blue in color. If flames lift off ports, are yellow, or are noisy when turned off, you may need to clean the burners.
ner e
To clean burners:
1.Lift the burner cap straight up from the burner base.
2.Remove the trim ring.
I
Typical surface burner flame at highest setting
3.Clean burner cap and trim ring with warm, soapy water and a sponge. You can also clean with a nonabrasive scrubbing pad or cleanser. Do not clean burner cap or trim ring in a dishwasher or selfcleaning oven.
4.if the gas tube opening or the orifice, located inside the opening, has become soiled or clogged, use a cotton swab or a soft cloth to clean the area. Then use a
11 |