RANGE CARE
CleanCycle
AquaLift™ Technology is an innovative cleaning solution that utilizes heat and water to release
Allow the oven to cool to room temperature before using the Clean cycle. If your oven cavity is above 200°F (93°C), “OVEN COOLING” will appear in the display, and the Clean cycle will not be activated until the oven cavity cools down.
To Clean:
1.Remove all racks and accessories from the oven cavity and wipe excess soil. Use a plastic scraper to remove easily- removed soils.
2.Pour 2 cups (16 oz [500 mL]) of distilled or filtered water onto the bottom of the empty oven and close the oven door.
IMPORTANT: Do not use chemicals or other additives with the water. Do not open the oven door during the Clean cycle. The water on the oven bottom is hot.
3.Press CLEAN and then START on the oven control panel.
4.Allow 40 minutes for cleaning and cool down. A beep will sound when the Clean cycle is complete.
5.Press CANCEL at the end of the cycle. CANCEL may be pressed at any time to stop the Clean cycle.
6.Remove the residual water and loosened soils with a sponge or cloth immediately after the Clean cycle is complete. Much of the initial 2 cups (16 oz [500 mL]) of water will remain in the oven after the cycle is completed. If additional soils remain, leave a small amount of water in the oven bottom to assist with the cleaning.
7.If any soils remain, remove them with a
IMPORTANT: Do not use oven cleaners. The use of chemicals, including commercial oven cleaners or metal scouring pads, may cause permanent damage to the porcelain surface of the oven interior.
NOTES:
■The range should be level to ensure that the entire surface of the bottom of the oven cavity is covered by water at the beginning of the Clean cycle.
■For best results, use distilled or filtered water. Tap water may leave mineral deposits on the oven bottom.
■Before removing the residual water and loosened soils at the end of the Clean cycle, insert a cloth or paper towel between the lower edge of the oven door and the front frame to keep water from spilling onto the front of the range and the floor.
■Soil baked on through several cooking cycles will be more difficult to remove with the Clean cycle.
■Nonabrasive scrub sponges or eraser style cleaning pads (without cleaners) can be effective for cleaning the oven cavity walls, oven door and oven bottom for difficult soils. For best results, moisten the pads and sponges before use.
■Run an additional Clean cycle for stubborn soils.
■affresh™ Kitchen Appliance Cleaner and affresh™ Cooktop Cleaner may be used to clean the oven bottom, walls and door when the oven has finished the cycle and returned to room temperature. Refer to the “Accessories” section for information on ordering.
■Additional AquaLift™ Technology Cleaning Kits may be obtained by ordering Part Number W10423113RP. See the “Accessories” section for more information.
■For assistance with AquaLift™ Technology, call
14