USING YOUR REFRIGERATOR
Removing the ice maker storage bin
Remove, empty, and clean the storage bin if:
•The ice dispenser has not, or will not, be used for a week or more
•A power failure causes ice in the bin to melt and freeze together
•The ice dispenser is not used regularly
To remove ice bin:
1.Pull the covering panel out from the bottom and slide it to the rear.
Quick Freeze |
2.Lift the signal arm so it clicks into the OFF (up) position. Ice can still be dispensed, but no more can be made.
3.Lift the front of the storage bin and pull it out.
4.Empty the ice bin. Use hot or warm water to melt the ice if necessary. Never use anything sharp to break up ice in the bin. This can damage the bin and dispenser mechanism.
5.Wash with mild detergent. Rinse well. Do not use harsh or abrasive cleaners or solvents.
6.When replacing the bin, make sure it is pushed in all the way. Then push the signal arm down to the ON position to restart ice production.
Removing the base grille
To remove the grille:
1.Open both doors.
2.Pull base grille forward to release the clips from the support holes.
3.Do not remove Tech Sheet fastened behind the grille.
To replace the grille:
1.Line up grille clips with support holes.
2.Push firmly to snap into place.
3.Close the doors.
See cleaning instructions for defrost pan and con- denser coils on page 24.
20