Removing and adjusting the freezer shelves...
LlFl THERIGHT SIDE THENSLIDE OUT
To remove the shelf:
1.Lift right side of shelf off supports.
2.Slide shelf out of shelf support holes.
3.Replace in reverse order.
To adjust the shelf:
1.Remove shelf.
2.Remove supports by sliding upwards.
3.Replace supports on desired level.
4.Replace shelf.
NOTE: The cup shaped supports go in the back of the freezer.
Changing the light bulbs...
Electrical Shock Hazard
Before removing a light bulb, either unplug the refrigerator or disconnect the electrlclty leading to the refrigerator at the main power supply. Shock and injury can occur If electrlclty remains connected.
GRASP LIGHT SHIELD PULL BOllOM FORWA
To change refrigerator light:
1.Disconnect refrigerator from power supply.
2.Reach behind the control console to find bulb.
1.Disconnect refrigerator from power supply.
2.Grasp front of light shield.
3.Pull bottom of shield forward until it snaps free.
4.Remove bulb.
5.Replace with a
6.Press light shield straight on until it snaps into place.
7.Reconnect power supply.
Optional automatic ice maker...
If you have the automatic ice maker accessory, or if you plan to add one later (Part No.
l The ON/OFF lever is a wire signal arm Down...for making ice automatically Up...to shut off the ice maker.
DO NOT TURN ICE MAKER ON UNTIL IT IS CON- NECTED TO THE WATER SUPPLY.
LOWER | RAISE |
SIGNAL | SIGNAL |
ARM TO | ARM TO |
START IT | STOP ICE |
l The dial or lever on the side of the ice maker changes the size of the cubes.
l Shake the bin occasionally to keep cubes sepa- rated, and to obtain increased storage capacity.
l It is normal for ice crescents to be attached by a corner. They will break apart easily.
l You will hear water running when ice maker iS working. You’ll hear ice fall into the bin. Don’t let these sounds bother you.
l The Ice maker WIII not operate until the freezer is cold enough to make ice. This can take overnight.
l Because of new plumbing connections, the first ice may be discolored or
continued on next page 7