WATER HEATING signal light
The WATER HEATING sig- nal light comes on auto-
matically during the HEAVY, NORMAL and LOW ENERGY Cycles to show
that water is being heated. The heating time is preset for each cycle, and heats the water a few
degrees to improve washability. The WATER
HEATING signal light will go off automatically when the preset heating time is up
NOTE: The water will stop heating once the preset time is up. If you want to make sure the water gets heated to 145°F (63”C), use the HI- TEMP Option (see page 10).
Selecting an extra feature
Four of the control pads serve two purposes. Besides the functions already listed, they control these extra features:
CONTROL PAD | START PAD | OPTIONS | PAD | CYCLE | PAD | DELAY PAD | |
EXTRA FEATURE | Begins CYCLE | Cancels | CLEAN | Locks | out | Turns “beep” | |
| PAUSE. | signal | light when | control | pads. | ON/OFF. | |
|
| door | is opened. |
|
|
|
These features are described below.
CYCLE PAUSE
A cycle can be stopped at any time for up to10 minutes.
/
B!!!!
1.To pause during a cycle, press the STARTpad. Any signal lights that are on will flash until the cycle restarts after 10 minutes.
I -
I!!!! /
2.The cycle can be started sooner by pressing the START pad again.
I
CLEAN signal light
To again have the signal light stay on when the door is opened:
other control pad is pressed.
As an option you can have the CLEAN light turn off the first time you open the door after a cycle is finished:
1.Press and hold the OPTIONS pad until the CLEAN signal light starts flashing.
2.Release the Dad.
1.Press and hold the OPTIONS pad until the ’ CLEAN signal light turns on.
2.Release the pad.