CONTROL PADS
Starting your dishwasher
Four control pads and the signal lights allow you to set and check the dishwasher’s function.
When first installed, the signal lights will flash rapidly in order. The signal lights will also flash following a powerfailure. Press the CANCEL pad twice to clear the signal lights.To start the dish- washer, press the STARTpad once to display the cycle. The dishwasher is preset for the NORMAL cycle with the HEAT DRY option. If you want this cycle, press STARTagain.
To select a different cycle and/or option, just press the CYCLE pad and/or OPTIONS pad until the cycle and/or option you want is indicated by the signal lights. Each press of the pad advances the signal light to the next cycle or option. Press START to begin the cycle you se- lected. After each use, the dishwasher remem- bers the cycle and options used. The next time the display is lit up for selection, it will show the last cycle that was run.
When dishes are loaded and ready to be
washed...
1.Read “Important Safety Instructions’on page 2 before starting your dishwasher.
2.Spin the Upper and Lower Spray Arms to make sure nothing will stop them from turning freely.
3.Push door firmly when closing and it will auto- matically latch.
4.Run hot water at sink nearest dishwasher until it is hot. Turn it off.
5.Press the STARTpad. Skip to step 7 if you want to run the cycle indicated by thesignal lights.
6.You may select a different cycle by pressing the CYCLE pad. You may select a different option by pressing the OPTION pad.
7.Press the START pad again.
Selecting a cycle
POTS & PANS
WASHING | AND | RINSING | AND |
HEATING | WATER | HEATING | WATER DRYING CLEAN |
Maximum | cleaning |
| for | |||||
or | foods. | The | cycle time |
|
| |||
delays while | the | dishwasher | auto- |
|
| |||
matically | heats the | water to | 145°F |
|
| |||
(63°C) in both washes and in the last |
|
| ||||||
rinse (marked *I. Cycle time** is 72 |
|
| ||||||
minutes | plus | the | time | needed | to |
|
| |
heat the | water. |
|
|
|
|
|
|
|
8