Whirlpool DU9100XT Series manual Energy saving tips

The CANCEL pad allows you to cancel a cycle, to clear the signal lights or to make a new selection. If the dishwasher is washing, it will

go into a 2 minute drain automarlcally DefOre shutting off. Pressing CANCEL again stops the drain. If the dishwasher had not been started or is not washing, it will clear the display. Pressing CANCEL again will start a 2 minute drain, if needed.

CLEAN signal light

The CLEAN signal light comes on at the end of a cycle to show that the load is clean. It will stay on until CANCEL or any other con-

trol pad is pressed.

1.Wash full loads. Running a half-filled dish- washer uses the some amount of electricity and hot water as a fully loaded machine.

3.load correctly for best washing results. In- correct loading may cause poor washing and the need to rewash all or port of the load.

6.Use your dishwasher during off-peak hours.

Local utilities recommend this to avoid heavy usage of energy at certain times of day

2.Air dry dishes when you don’t need a rapid drying cycle. Allow longer drying times (overnight].

4.Don’t pre-rinse normally soiled dishes. Se- lect the correct cycle for the load and use

the recommended amount of detergent for good washing results without hand rinsing.

6.Kitchen cleanup can be done quickly and efficiently through the use of your dishwasher.

Most appliance parts that can fit in the dish- washer can be cleaned by it. Burned-on soil, however, should be cleaned by hand.