faucet
adapter 4
locking collar
bleeder button
faucet
adapter w
locking
14.
When the cycle is completed, turn the water “OFF.”Press the red button [bleeder button) on the connector to release water pressure. With one hand, move the locking collar downward while using the other hand to pull down on the connector. Turn the connector upside down to empty any water remaining inside the connector, Check for complete drain (no water should be visible).
bleeder button
15,
Push hoses into storage compartment.
Untape the electrical cord and-
into the grounded outlet. Open the I dishwasher door and spin the spray
arm to check for movement. Close the
door.
dishwasher. To make sure you get the
12, | most efficient use and greatest |
|
enjoyment from your new dishwasher, |
| |
Slowly turn on hot water to fully open | ( Congratulations! | \ |
position. Start dishwasher. |
|
|
Installation
10.
Turn on hot water until water is hot. Turn faucet off. Pull the inlet/drain hose from the storage compartment. Attach the hose connector to the faucet by pulling down on the locking collar while pushing the connector over the faucet adapter. It will snap into place. Release the locking collar.
PANEL C
Check for leaks around the door, / mounting gasket, and at the hose connections. Open door and check water level, Water shoutd just cover the round heater element. Close door and allow dishwasher to complete one cycle.
To convert a front loading portable dishwasher into a
I