Problem
Spotting and Filming (continued)
Cycle Takes
Extremely Long
Time
Dishes Do Not Dry Completely
Silica Film or Etching (Silica Film is a White Irides- cent Deposit; Etching is a Cloudy Film)
Black or Gray Marks on Dishes
Cause
Water temperature is too low
Use of incorrect detergents
Incorrect amount of detergent
Use of ineffective detergents
Insufficient fill caused by low water pressure
Water temperature is too low
Dishes do not drain PropeN
Plastics
A water chemical reaction with certain types of glassware. Usually caused by some combination of soft or softened water, alkaline washing solutions, insuffiiient rinsing,
Aluminum items
Solution
Use the
Use recornrnended dishwasher deter- gents onfy.
Follow recommendations on page 11 for amount. Heavy soil and/or hard water generally require extra detergent.
Detergent should be fresh. Store in a cool, dry place, preferably in an airtight container. Discard lumpy detergent.
Home water pressure should be 20 to 120 psi for proper dishwasher fill. A booster pump on the water supply may be necessary if pressure is too low.
If needed, turn home water heater up to ensure water entering dishwasher is 120°F (49°C) minimum. See recom- mended procedure on page 13.
Dishes must have proper- water drainage Do not overload. Follow instructions for loading dishwasher on pages
Some plastics, due to material, may need to be towel dried.
It may not be possible to prevent prob- lem, except by
Aluminum items should be loaded so that they will not rub against dishes during washing.
22