Whirlpool 9200 SERIES manual TheWATERHEATINGsignal light, TheCLEANsignal light, Door is opened

TheWATERHEATINGsignal light

The WATER HEATING signal light comes on during the water heating portions of the Pots 8 Pans Cycle. The signal light will also come on during the water heating portion of other cycles when the Hi-Temp Option is selected.

The WATER HEATING signal light will flash at the end of the cycle if the water did not heat to 140°F (60%). If you want to make sure the water gets heated to 140°F (SO’C), use the Hi-Temp Option (see page 10).

When the signal light is on, water is being heated. The heating time is based on the tempera- ture of the water supply as it enters the dish- washer. The cooler the water, the longer the heating time. The WATER HEATING signal light will go off when the water temperature reaches 140°F (SOOC).

TheCLEANsignal light

The CLEAN signal light comes on at the end of a cvcle to show that the load IS clean. It will stay on until CANCEL/DRAIN or any other control pad is pressed.

As an option, you can have the CLEAN light turn off the first time you open the door after a cycle

is finished:

1. Press and hold the CYCLE pad until the

	CLEAN signal light starts flashing.
	2. Release the pad. The CLEAN signal light will
	turn off.
	NOTE: A power failure will reset this feature. You
C	will have to redo the above steps.
	To again have the signal light stay on when the
	door is opened:
	1. Press and hold the CYCLE pad until the CLEAN
	signal light turns on.
	2. Release the pad. The CLEAN signal light will
	turn off.

7