installation Instructions
Before you begin operating the oven, carefully read the following instructions.
Installing your microwave oven
1.Empty the microwave oven and clean inside it with a soft, damp cloth. Check for damage such as misaligned door, damage around the door, or dents inside the oven or on the exterior. If there is any damage, do not operate the unit until it has been checked by an authorized WhirlpoolSM service technician and any repairs made.
Fire, Electrkal Shock, Excesslvo Ex~o-
sure To Mlcrowave Energy, Personal
InJury and Product Damage Hazard
lDo not block the rear air intake openings or exhaust vents. Allow a few inches of space at back of oven where intake opening and exhaust vents are located. Blocking the air intake openings and exhaust vents can cause damage to the oven and poor cooking results. Make sure the microwave oven legs are in place to ensure proper airflow.
lDo not install the oven next to or over a heat source (for example, a cooktop or range). Also, do not install oven in any area where excessive heat and steam are generated. This could cause a fire, electrical shock, excessive exposure to microwave energy, other personal injury or damage to the outside of the cabinet.
2.Put the oven on a cart, counter, table, or shelf that is strong enough to hold the oven and the food and utensils you put in it. (ll~e control slde of the unlt Is the heavy side. Use care when handllng.) The weight of Model MT2070XA is approximately 35 Ibs (15.75 kg). The weight of Model MT3090XA is approximately 50 Ibs (22.5 kg). The microwave oven should be at a temperature above 50°F (10%) for proper operation.
Exhaust vents
(Model MT3090~ only)
(Rear exhaust vents for Model MT2070XA- not shown)
Power | supply |
|
cord |
|
|
Exhaust | vents (not sho?m) | Air intake openings |
|
|
Built-in kits
You can build your microwave oven into a wall or cabinet by using one of the following kits. Do not build in your microwave oven within 2 feet of any gas or electric range, cooktop or oven.
For Model MT3OQOXA:
-24’ for black models (MK30Q4XAB [43 192491)
For Model MT207OXA:
-24’ for black models (MK2074XAB [4378054])
-24’ for white models (MK2074XAQ [4378053])
These kits are available from your Whirlpool Dealer. If your dealer does not stock the kii, it can be ordered by writing to:
Whirlpool Corporation
Attention: Customer Service Dept.
1900 Whirlpool Drive LaPorte, IN 46350
OR by returning the customer order card enclosed with your Use and Care Guide.