Whirlpool MW8750XL warranty Time, About the Quick Defrost Cycle

Page 9

3.Touch Number Pads for

the defrosting time you want.

count down

The QUICK DEFROST Signal Light will stay on to show that the oven is in the QUICK DEFROST Cycle.

The Display counts down the time to show how much defrosting time is left.

When the defrost time ends, you will hear 4 beeps. [You can stop the beeping by opening the oven door or touching CANCEL.) When the beeping stops, the Display will show the time of day.

STANDING

TIME

 

 

 

 

 

For best results, allow

the food to stand

for a while after defrosting. This helps equalize

the temperature

of the

food

to

provide

more even defrosting.

 

When

COOK

CYCLE

1 follows

QUICK

DEFROST, the oven automatically

provides a

standing

time

equal to the

time touched

in for QUICK DEFROST. COOK

CYCLE 1 will

begin after the automatic standing time.

 

For a different standing time:

 

 

 

I. Touch

QUICK DEFROST and

desired

time.

 

2.Touch COOK CYCLE 2.

3.Touch numbers for desired standing time.

4.Touch COOK POWER.

5.Touch “0”for zero Cook Power.

6.Touch START.

When the QUICK DEFROST is over, the oven will shut off The Display will count down the time for COOK CYCLE 2 at zero Cook Power. You will hear 4 beeps when the standing time is over.

ABOUT THE “QUICK DEFROST” CYCLE

The

microwave

oven

automatically

divides the time set for the QUICK

DEFROST

Cycle into three equal parts:

 

 

 

 

- First part

 

 

 

80%

of full

Cook

Power;

-Second

part

 

 

50%

of full

Cook

Power;

-Third

part

 

 

 

20%

of full

Cook

Power.

This automatic

step-down

in Cook Power is an important part of the QUICK DEFROST

Cycle.

It helps

defrost

food

quickly

and completely.

 

 

 

You can change the time setting any time while the QUICK DEFROST Cycle is operating:

1.Touch QUICK DEFROST.

2.Touch numbers for the new time.

3.Touch START.

Any

new

time setting

made

while

QUICK

DEFROST

is operating

will continue the

defrosting

only

at

20% of full Cook Power.

 

 

 

The

best

time

to

change

the

setting

is near

the end

of the QUICK

DEFROST Cycle.

1.Open the door.

2.Check the food with long-tined fork; if center area is hard frozen, set additional time. Remember that standing time will further defrost the food.

3.

Close the door and touch

START to continue the cycle if no additional

time is

 

needed.

 

 

9

4.

Or, touch in new instructions

if additional

time is needed.

 

Image 9
Contents Microwave Oven Model MW8750XL Contents Your microwave Must be Installed Microwwe Oven Controls Using your miaowave ovenUsing the Minute Timer Setting the ClockDo this Touch Number Pads for the correct time of dayCooking in ONE Cycle Control Panel ON/OFF SwitchTouch Cook Power Lower Cook PowersChanging the Cooking Time CountTouch a Number Pad for the Cook Power you want Changing Cook PowersDefrosting Put frozen food in the oven and close the doorAbout the Quick Defrost Cycle TimeQuick DefrostEial e Changing or Adding Instructions Liiia‘Using Pause Adding PauseStart Cookingautomaticallyafterdefrosiing EiinSame amount of tlme used for defrost Using Keep Warm Put cooked, hot food in oven and close doorTouch Keep Warm Keep Warm Cooking with the Temperature ProbeCancel Toudh the Number Pad for the Cook Power you want Touch StartChanging the Temperature Setting Delayed StartHints for Using the Temperature Probe Cleaning the ProbeExtra Informatlon Changing or Adding InstructionsDo not Touch in Pause Cook Temp NextProgramming Tone Cancelling InstructionsChanging or Adding Cook CycleOther Operating Hints Cleaning the microwave ovenLevel cooking rack Cleaning the RackReplacing the fight bulb Special CautionsImportant information Rough or harsh cleaners can scratch or dull Building in your microwave oven Ovens workShelf RDE, REE1l Before calling for assistance 3l If you need service