Whirlpool YMT4155SP manual Cooking in Stages, Sensor Popcorn, Sensor Cooking

Cooking in Stages

The oven can be set to cook at different cooking powers for various lengths of time, up to 3 stages, plus a defrosting stage and a warming stage.

To Cook in Stages:

1.Touch COOK TIME.

“STAGE 1 ENTER COOK TIME” will scroll across display. Enter the length of time to cook during the 1st stage.

2.Touch COOK POWER, then enter the desired cooking power for the 1st stage. See “Cooking Power.”

3.Repeat steps 1 and 2 for each additional stage.

Warm Hold may be programmed to follow the last stage.

4.Touch START.

Two tones will sound between stages.

When the cycle ends, “END” will appear in the display, and the end-of-cycle tones will sound, followed by reminder tones.

5.Touch OFF-CANCEL or open the door to clear the display and/or stop reminder tones.

Cook time may be added in 30-second increments during the cycling stage by touching JET START™ control.

Sensor Popcorn

The sensor in the microwave oven determines the appropriate popping time of commercially packaged microwavable popcorn.

■Do not use regular paper bags or glassware.

■Pop only 1 package of popcorn at a time.

■Follow manufacturer’s instructions when using a microwave popcorn popper.

■Listen for popping to slow to 1 pop every 1 or 2 seconds, then stop the cycle. Do not try to pop unpopped kernels.

■Use fresh bags of popcorn for optimal results.

■Cooking results may vary by brand and fat content. For bag sizes not listed in this section, follow package directions.

There are 2 popcorn functions: Regular and Snack. Use Regular for bag sizes 3.5 oz (99 g) and 3.0 oz (85 g). Use Snack for bag size 1.75 oz (50 g).

To Use POPCORN:

1.Place popcorn bag on the turntable.

2.Touch POPCORN once for Regular, or twice for Snack.

Touch START, or wait for the oven to start the popping cycle automatically.

When the cycle ends, “END” will appear in the display, and the end-of-cycle tones will sound, followed by reminder tones.

3.Touch OFF-CANCEL or open the door to clear the display and/or stop reminder tones.

Sensor Cooking

The sensor in the microwave oven detects humidity released from the food and automatically sets a cooking time based on the selected pad. Use the following chart as a guide.

FOOD	SERVING	INSTRUCTIONS
	SIZE
Baked	1-4 medium,	Pierce each one several times
Potatoes	10-13 oz	with a fork. Place on turntable
	(283-369 g)	around edges, at least 1"
	each	(2.5 cm) apart. At the end of
		cooking, let stand 5 minutes
		after cooking.
Frozen	1-4 cups	Remove from package. Place in
Vegetables	(250 mL-1 L)	microwavable container. Cover
		with plastic wrap and vent. Stir
		and let stand 2-3 minutes after
		cooking.
Fresh	1-4 cups	Place in microwavable container
Vegetables	(250 mL-1 L)	and add 2-4 tbs (30-60 mL)
		water. Cover with plastic wrap
		and vent. Stir and let stand
		2-3 minutes after cooking.
Frozen	10-20 oz	Remove from package. Loosen
Entrée	(283-567 g)	cover on three sides. If entrée is
		not in microwavable container,
		place on plate, cover with plastic
		wrap and vent.
Rice	0.5-2 cups	Follow measurements on
	(125-500 mL)	package for ingredient amounts.
	dry rice	Place rice and liquid in
	(Use medium	microwavable dish. Cover with
	or long grain	loose-fitting lid. After cooking,
	rice.)	let stand 5 minutes, or until
		liquid is absorbed. Stir.
Fish	0.25-2 lbs	Place in microwavable dish.
	(113-907 g)	Cover with plastic wrap and
		vent. Let stand 2-3 minutes after
Seafood
		cooking.

NOTE: When covering foods, make sure the vent opening is large enough for the moisture to escape. This will allow the sensor to accurately determine cooking time.

To Use Cook:

Before using, make sure the microwave oven has been plugged in for at least 3 minutes, the room temperature is not above 95°F (35°C) and the outside of the container and microwave oven cavity are dry.

1.Place food on the turntable and close the door.

2.Touch COOK until the desired food type is displayed.

The microwave oven will start automatically after a brief delay.

When the cycle ends, “END” will appear in the display, and the end-of-cycle tones will sound, followed by reminder tones.

3.Touch OFF-CANCEL or open the door to clear the display and/or stop reminder tones.

10