Whirlpool KEMI301G, KEMI371G manual Electronic Oven Control, Displays, Clock, Tones

ELECTRONIC OVEN CONTROL

2 3 4 5 6

7 8 9 10

1.	Oven Display	4.	Time of Day/Timer Display	8.	Timed and Delayed Cooking
2.	Lower Oven Start and Cancel	5.	Timer Pads		Pads
				9.
	Pads	6.	Clock Set/Start Pad		Oven Light Pad
3.	Number Pads			10.	Upper Microwave Oven
		7.	Oven Setting Pads

Control Panel

Display(s)

When power is first supplied to the appliance, everything on the display(s) will light up for 5 seconds. Then, “PF id = 27” or “PF id = 30” will appear. Press LOWER OVEN CANCEL, UPPER OVEN CANCEL or CANCEL OFF (on some models) to clear display(s).

Any other time “PF id = 27” or “PF id = 30” appears, a power failure occurred. Depending on your model, press LOWER OVEN CANCEL, UPPER OVEN CANCEL, CANCEL or CANCEL OFF and reset the clock if needed.

Lower Oven Display (combination oven models)

When the lower oven is in use, this display shows the lower oven temperature, heat source(s) and start time.

During lower oven Timed Cooking, this display also shows a vertical bar and minute time countdown and the stop time (if entered).

If “Err” appears on the display, an invalid pad was pressed. Depending on your model, press LOWER OVEN CANCEL, UPPER OVEN CANCEL, CANCEL or CANCEL OFF and retry your entry.

When the lower oven is not in use, this display is blank.

Upper Oven Display (combination oven models), Display (single oven models)

When the upper oven or single oven is in use, this display shows the upper oven or single oven heat source(s), cooking power, quantities, weights and/or help prompts.

If “RETRY” flashes on the display for one second, an invalid pad was pressed. Retry your entry.

When the upper oven or single oven is not in use, this display shows the time of day or Timer countdown.

Clock

This is a 12 hour clock and does not show a.m. or p.m.

To Set:

Before setting, make sure the ovens, Timer and Timed Cooking are off.

1.Press CLOCK SET/START.

2.Press the number pads to set the time of day.

3.Press CLOCK SET/START, START or EASY MINUTE START.

To remove the time of day from the display: Press and hold

CLOCK SET/START for 5 seconds.

To return the time of day to the display: Press CLOCK SET/ START. The time should not have to be reset.

Tones

Tones are audible signals, indicating the following:

One tone

■Valid pad press

■Oven is preheated

■Function has been entered

Three tones

■Invalid pad press

Four tones

■End-of-cycle

■Reminder, repeating each minute after the end-of-cycle tones

All Tones (combination oven models only)

All of the above tones are preset on, but can be turned off.

To Turn Off/On: Press and hold STOP TIME for 5 seconds. A tone will sound and “Snd oFF” will appear on the lower oven display for 3 seconds. Repeat to change back to “Snd on.”

8