Whirlpool Electric Built-In Microwave/Oven Installation Requirements, Tools and Parts

Page 2

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.

Tools needed

Phillips screwdriver

Measuring tape

Hand or electric drill (for wall cabinet installations)

1" (25 mm) drill bit (for wall cabinet installations)

Level

Parts needed

UL listed or CSA approved conduit connector

UL listed wire connectors

Parts supplied

# 8–14 x 1" screws - single oven (2), double oven (4)

Bottom vent (supplied on some models)

Two # 8–18 x ³⁄₈" screws - bottom vent (supplied on some models)

Side trim

Check local codes. Check existing electrical supply. See “Electrical Requirements.”

It is recommended that all electrical connections be made by a licensed, qualified electrical installer.

Built-In Microwave/Oven Combination

Location Requirements

IMPORTANT: Observe all governing codes and ordinances.

Cabinet opening dimensions that are shown must be used. Given dimensions provide minimum clearance with oven.

Recessed installation area must provide complete enclosure around the recessed portion of the oven.

Grounded electrical supply is required. See “Electrical Requirements” section.

Electrical supply junction box should be located 3" (7.6 cm) maximum below the support surface when the oven is installed in a wall cabinet. A 1" (2.5 cm) minimum diameter hole should have been drilled in the right rear or left rear corner of the support surface to pass the appliance cable through to the junction box.

Oven support surface must be solid, level and flush with bottom of cabinet cutout. Floor must be able to support a total weight (microwave and built-in oven) of 238 lbs (108 kg).

IMPORTANT: To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate or sustain other damage. This oven has been designed in accordance with the requirements of UL and CSA International and complies with the maximum allowable wood cabinet temperatures of 194°F (90°C)

Product Dimensions

27" (68.6 cm) and 30" (76.2 cm) Ovens

A

B

E

 

 

 

C

 

 

 

 

D

 

 

 

 

27" (68.6 cm) models

30" (76.2 cm) models

A. 25⁵⁄₁₆" (64.3 cm) recessed

A. 28⁵⁄₁₆" (71.9 cm) recessed width

width

B. 42³⁄₈" (107.6 cm) overall height

B. 42³⁄₈" (107.6 cm) overall height

C. 29³⁄₄" (75.6 cm) overall width

C. 26³⁄₄" (67.9 cm) overall width

D. 23" (58.4 cm) max. recessed

D. 23" (58.4 cm) max. recessed

depth

depth

E. 41" (104.1 cm) recessed height

E. 41" (104.1 cm) recessed height

 

2

Image 2
Contents Instructions Dinstallation DE Lensemble Four À MICROWAVE/OVEN CombinationBuilt-In Microwave/Oven Combination Location Requirements Installation RequirementsTools and Parts Electrical Connection Cabinet DimensionsElectrical Requirements Cabinet Side ViewRemove Oven Trim Installation InstructionsPrepare Built-In Microwave/Oven Combination Remorve Oven DoorWire Cable from Home Power Supply Install OvenElectrical Connection Options Chart Wire Cable from Home Power Supply U.S. OnlyCheck Operation of Microwave Oven Complete InstallationCheck Operation of Lower Oven If ovens does not operate, check the followingOutillage et pièces Exigences DinstallationConventionnel Encastrés Spécifications électriques Dimensions du produitDimensions du placard Vue latérale du placardDépose de la garniture du four Instructions DinstallationDépose de la porte du four Câblage de la maison Voir la section Raccordement électriqueTableau des options de raccordement électrique Installation du four Vérification du fonctionnement du four à micro-ondes Achever linstallationVérification du fonctionnement du four inférieur Si les fours ne fonctionnent pas, contrôler ce qui suit