Install properly...
3I[- II a-1 ”L
1 Check the strength of the floor It should hold the delght of a fully loaded freezer
2 Pick a safe place, indoors, away from in-
flammables such as gasoline.
3 Allow 3 Inches (7 5 cm] arr space on top of freeze for proper ventrlotrori
4 Allow at least an Inch (2 5 cm) be+,eerl trIc freezer condenser, on the bock of the ilr!rt 3r:c the wall
5 Allow ’ . inch [I 25 cnj on each side of +he ‘reeze: for ease of Installatron
6 If the freezer IS to be agarnst a wall V::U rrrgiit want to leave extra space on the hinge side so the door can be opened wider
,’ The four bolts that held your freezer ir the Shipis~rig crate are designed to be the levellrng legs Screw the legs far enough into the bolt holes, in each of the four bottom corners, so the freezer stands about 1 Inch (2 5 cm] off the floor
Remove sales labels...
Remove the Consumer Buy Guide label and any inside labels before using the freezer
To remove any remaining glue:
1 Rub briskly with thumb to make a ball, then remove
OR
2 Soak area with dtshwashing detergent solution (1 teaspoon detergent In 1 quart warm water] be- fore removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the material.
NOTE: DO NOT REMOVE the Tech Sheet fas- tened under the freezer at the front.
Clean it...
Ciean your freezer befor using It See cleanrng lnstrcctlons on page 6
Plug it in...
Level freezer...
so the door wtll stay coen at any positior
Levelling Leg
Lower Raise
Start adjustment with the door hinge side. 1 Slide freezer into place
2 Adjust front legs to level the freezer
To raise front, turn legs In direction shown
~To lower front, turn legs In directron shown 3 Check with level
4 After freezer IS fullv loaded recheck iyrfh levei
grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused and properly grounded electrrcal supply is re-
quired It IS recommended that a separate circuit serving only this appliance be provided
Do not use an extension cord. Use a recep- tacle which cannot be turned off with a switch or pull chain. See individual electrrcal require- ments and grounding Instruction sheet in your Irter- ature package
4