: :LI i / i | Li | ! | i¸¸: | Ui | IU! | ? |
Whe nthe left door isclosed, the hingedsection automaticallyforms
WATER CONNECTION
Disconnect the appliance from the mains power supply before starting operations.
•The ice maker and water circuit must be connected to a water supplyof potable and/or chemicallypurified water.
•The water connectionmust be carried out in cornpliancewith localregulations.
•The appliance issuppliedwith a water tube and with a transition connector for connectingto the water tube and supply. (some models)
•Remove the protective cap from the end of the gray water tubing.
•Connect the water tube (I) to the transition connector (2). Finger tightening and then I to 2 additional turns should be adequate (for some models connector is placed directly on water tube).
•Connect the transition connector (2) to the household water supply (3).
•(4) Remove Plastic cap from water valve inlet port.
•(5) Place end of Plastic tubing into water valve inlet port.
•(6) Slide brass nut over sleeve and screw nut into inlet port. Tighten nut with wrench. Do not overtighten. Connect tubing to frame with water tubing clamp (C).
•Make sure that the water tube is not twisted.
•The appliance is
2.4and 8.3 bar (35 and 120 PSI).
•Open the water tap. Check for and eliminate any leaks.
•The appliancedoes not require any adjustment or water drain.
c .....i iiililiHHilHiilliii!iHl