Whirlpool manual Freezer Handles, 216

Freezer Handles

Partial-Width Handle

Materials Needed

• Phillips screwdriver

/

To Install:

I. Install handle by fastening with screws removed from edge of door.

• [freversingfreezerdoor. removedoor plugs from top edge of door and insert into screw holes.

To Remove:

Remove handle screws with Phillips screwdriver and retain screws for later use.

Front Hount Handle - style 2

Haterials Needed

•Gloves to protect hands

•Phillips screwdriver

•Plastic door removal card (or 0. I cm thick plastic card), cetain the card

Attach Extensions to Handle: (select models)

I.Align handle and extension as shown.

2. Place extension in handle opening.

3.Apply slight pressure to both sides of the extension piece. 4.Slide extension until it stops on inside edge of handle.

To Install:

I .The handles are to be oriented as shown.

2.Align front mount door handle clip with the door tabs.

3.Ensure the handle clips are positioned slightly above the door tabs.

4.Rotate the handle so that the handle is flat against the door.

5.Push the handle down against the upper door tab just enough to allow it to hang unsupported.

6.Align bottom of handle with lower door tab. Press upper handle end to door surface and firmly grasp lower end of handle. Gently slide handle upward until bottom of handle settles an door surface, then reverse direction, sliding downward to almost engaging tab with clip.

7.Grasp the handle firmly and slide down until it clicks. The audible click indicates fastening clips are securely interlocked.

To Remove:

I. Flex the handle away from the door panel. Simultaneously place door handle removal card underneath the base of the lower handle. Insert the card to the line or until it stops.

2.Grasp the lower part of the handle firmly and lift to remove.

216