Bottom basket.. .
To remove:
l Lift up, then pull o To replace:
0 Insert into rear sli
0 Lower into place.
l Push basket into freezer.
Chanlging light bulb.. .
1.Unpl .Jg power cord.
2.Rem:)ve light shield by pulling away from the side wall.
3.Replxe bulb with 40 watt appliance bulb.
4.To replace shield, insert tabs into slots in wall and press.
5.Plug gower cord into outlet.
Cleaning your freezer
This freezer should be cleaned when frost has built up to about l/4 inch (6 mm) thickness. Com- plete defrosting and cleaning should be done at least once a year. In high humidity areas, a freezer may need more frequent defrosting.
To defrost and clean:
I. Turn Cold Control to OFF.
2.Unplug power cord.
3.Take out all food and removable parts.
Note: Wrap frozen foods and packages in sev- eral layers of newspaper and cover with a blan- ket. Food will stay frozen several hours.
4.Place pans of hot water inside freezer to speed melting of frost. Keep door open. Ice can be removed in large pieces as it melts.
Direct air from electric fan into freezerto speed defrosting.
5.Remove base grille, see page 7.
6.Unclip hose and allow water to drain through hose into a flat pan.
7.Clecln freezer according to the following direl::tions.
After du+frosting:
1.Hool drain hose in place.
2.Repl :rce base grille.
3.Plug In power cord.
4.See :lirections for “Setting the Cold Control,” pagci: 5.
Removing the base grille...
|
|
|
|
|
|
|
|
| support Tabs |
|
|
| To repkrce: |
|
|
| |||
|
|
| 1 | Line | u | :I grille | support | tabs with metal clips | |
2. | Pull grille outwards | a\s shown. | 2 | Push | f | ,mly | to | snap | Into place |
3. | Do not remove Tech sheet fastened behlnd grrlle | 3. | Close |
| the | door |
|
7