Before starting your freezer, To stari freezer

Before starting your freezer

1.locate it properly - For best

performance, your freezer

should be located in a cool, dry,

well-ventilated place out of the direct sunlight and away from such heat sources as radiators. The freezer may be installed flush against the wall and the cabinets on each side. Also, check the strength of your floor. Make certain it can support the weight of the freezer when loaded.

2.Keep it level - Level your freezer by adjusting the two leveling legs at the front corners. (Adjust door-hinge side first.] Turn left to raise the corner’ right to lower it. When freezer is sitting level, the freezer door (when opened) will stay at any open position. After the freezer has been filled, recheck to see if it is sitting level.

NOTE: Before turning freezer on, you may wantto wash the inside of the freezer with a solution of

two tablespoons baking soda to a quart of warm water. Rinse thoroughly and dry.

To stari freezer

Electrical Connection-Your

freezer should be connected to its own individual outlet, one not controlled by a wall switch.

Makesuretheoutlet provides120 volt, 60 Hz AC current. For your safety, the power supply cord of the freezer is equipped with a

three-pronged grounding plug. It should be plugged into a matching grounded three- pronged type wall receptacle. Attach retaining clip for cord plug. Do not remove the ground prong. See electrical require- ments and grounding in- structions sheet for complete information.

Set cold control -The cold control is located inside your freezer on the right wall. To start turn cold control to middle of dial. This position will maintain

zero zone temperatures under normal operating conditions Turn the cold control to a higher number for colder temperatures or a lower number for less cold temperatures.

Let freezer cool before filling - Allow freezer to cool 6 to 8 hours before filling with frozen food.

Let it cool overnight before add- ing a quantity of fresh food to be frozen. As freezer cools, you will see frost forming on the shelves.

It is normal for the frost to form first on the top shelves, and be heaviest there.

NOTE: When freezer first starts, the compressor will run all the time until the cabinet is cooled to selected temperature. This first cooling may take 6 to 8 hours or

longer depending upon the weather and the number of times the freezer door is opened. After the cabinet has cooled, the compressor turns off. It will turn on and off as needed to keep the freezer at selected temperature.

The Power Saving Control is lo- cated inside the freezer. It con- trols electric heaters in the walls of the freezer that helps reduce

condensation of moisture on the outside of the freezer during periods of high humidity When