Taking care of your freezer, Key eject lock

humidity in room is high, push switch toward HI to prevent

condensation. When humidity is low, push switch toward LO to conserve electricity.

Exterior signal light - Located on the right side of the base grille,

automatically indicates any power interruption to the freezer. When power is being supplied. the light will glow If light does not glow, check immediately.

The electrrc current may be off; the freezer may be discon- nected from the outlet; or the warning light may be burned out.

l&Y%&

Taking care of your freezer

Defrosting and cleaning

Complete defrosting should be done a bout once a year. For in- between defrosting, remove frost by scraping with CI plastic scraper. Do not use an ice pick, knife or other sharp-pointed

tool. You could damage the refrigerant coils.

2.Turn cold control to OFF, and disconnect service cord from wall outlet.

Key eject lock

Your freezer is equipped with CI key eject lock which can help reduce the hazard of child en- trapment. To lock or unlock the freezer it IS necessary to man- ually hold the key tn the lock whrle turning. The lock IS spring loaded so tne key can not be left In the lock

If key is lost, a replacement can be obtained from {our dealer or a Whirlpool TECH-CARE service agent Always give complete model and serial numbers of your freezer when requesting a

replacement key

FOLLOW THESE STEPSWHEN DEFROSTING AND CLEANING:

1 Remove frozen foods and wrap packages individually In several thicknesses of newspaper and cover with a blanket. Food handled this way will stay frozen several hours

3.Take out glide-out basket. Wash in warm, soapy water; rrnse and dry

To remove glide-out basket at bottom, pull it out until it stops. Lift basket up and out. To replace, insert basket into rear slides and lower into position. Push basket into freezer.