Select Blower Option and Installation Type

1. SELECT BLOWER OPTION AND INSTALLATION TYPE

1.1NON-DUCTED INSTALLATION

For a non-ducted installation, a non-duct kit ANKE60 Series (sold separately) must be installed. For maximum effectiveness, we recommend installing this kit with a single (internal) blower hood. The kit fits hoods from 30-inch width up to 48-inch width. See installation instructions included with the non-duct kit ANKE60 Series.

1.2DUCTED INSTALLATION

The Broan Elite E64000 Series range hood includes many configurations: hood with single or double internal blowers (included with the hood), or hood using external blowers. For hood using external blowers, the Broan Elite E64000 Series must be installed with in-line blower models HLB3, HLB6, HLB9 or HLB11, or exterior blower model 331H, 332H, 335 or 336 only. Other blowers cannot be substituted. (Blowers sold separately).

Plan where and how the ductwork will be installed.

If installing in-line blower, refer to instructions packed with in-line blower and follow steps 1, 2, 3, 4, 10 and up of this manual.

Install proper-sized ductwork, elbows and roof or wall cap for the type of blower you are installing. If using 7”, 8” or 10” round ducts, use a transition (internal blower(s) only). Use 2” duct tape to seal duct joints.

The minimum hood distance above cooktop must not be less than 24’’. A maximum of 30” above cooktop is highly recommended for best capture of cooking impurities.

Distances over 30” are at the installer and users discretion.

Roof cap

Wall cap

3¼” x 10” duct

or 7” or 8” round duct

3¼” x 10” to 7” or

3¼” x 10” to 8” transition (if using round duct)

Hood

24” minimum above

cooking surface

Wall cap

Roof cap

10” round duct

4½” x 18½” to 10” transition

Hood

24” minimum above cooking surface

HH0085A

HH0086A

SINGLE INTERNAL BLOWER

TYPICAL DUCTWORK

Exterior blower

10” round duct

Hood

24” minimum above cooking surface

HH0087A

MODEL 331H, 332H, 335 OR 336

DOUBLE INTERNAL BLOWERS

TYPICAL DUCTWORK

Roof cap

10” round duct (except HLB3, 8” round duct)

In-line blower

Wall

cap

Hood

24” minimum

above cooking

surface

HH0092A

MODEL HLB3, HLB6, HLB9 OR HLB11

EXTERIOR BLOWER	IN-LINE BLOWER TYPICAL DUCTWORK
TYPICAL DUCTWORK

- 5 -