Broan PM390HS warranty Install the Ductwork, Connect Ductwork, Install the Hood

INSTALL THE DUCTWORK

NOTE: To reduce the risk of fire, use only metal ductwork.

1.Decide where the ductwork will run between the hood and the outside.

2.A straight, short duct run will allow the hood to perform most efficiently.

3.Long duct runs, elbows, and transitions will reduce the performance of the hood. Use as few of them as possible. Larger ducting may be required for best performance with longer duct runs.

4.Install a roof or wall cap. Connect round metal ductwork to cap and work back towards hood location. Use duct tape to seal the joints between ductwork sections.

ROOF CAP

ROUND

DUCT

WALL

B

min 7/16” max 13/16”

FIG. 4 FIG. 5

CONNECT DUCTWORK

Ducted Configuration

1. Take the damper and assemble it onto the hood’s discharge

POWER MODULE

CAP

6”

	opening, pressing slightly.
2.	Use 6" round metal duct to connect the discharge collar on the
	hood to the ductwork above.
3. Use duct tape to make all joints secure and air tight.

ROUND

ELBOW

24” TO 30” ABOVE

COOKING SURFACE

FIG. 1

INSTALL THE HOOD

NOTE: the hood has to be installed, inside the cabinet, at minimum 1” from the rear wall cabinet and at 3” from the front wall cabinet.

The internal height of cabinet has to be minimum 16”.

The hood should be mounted centered over the cook top burners.

1.Remove the grid by moving the 2 slide fasteners “A” forward (Fig.2).

2.Cut a hole in the bottom of the cabinet, using the dimensions shown (Fig. 3).

3.Adjust the position of the clasping side spring by means of the proper “B” screw according to the thickness of the bored panel to which it is going to be anchored (Fig. 4).

4.NOTE: For installations where the Power Pack is less than 30” above cook top, it is recommended that the Power Pack be mounted into a metal liner or non-combustible material. This will allow easier cleaning and provide protection to the cabinetry.

5.Insert the hood in the cabinet and lock it by means of the side spring.

6.Insert the hood in the cabinet and secure with the (4) “C” mounting screws 3.2x13mm (Fig. 5). For alternative side fixing use M4x15mm screws with washers and nuts.

7.In the Non-Ducted Recirculation Configuration, install the Non- ducted recirculation Filter before replacing the grid (see section “Non-ducted recirculation filter installation”).

Non-Ducted Recirculation Configuration

1.Connect a 6” round metal duct to the discharge opening so that the air is sent outside the cabinet and sent back into the room.

2.Use duct tape to make all joints secure and air tight.

NON-DUCTED RECIRCULATION FILTER INSTALLATION

1.Remove the metal wires (Fig. 9) and discard them.

2.Install the Non-ducted recirculation filter over the grease filter and secure it with the metal wires supplied with the Non-ducted recirculation Filter (Fig. 6).

NON-DUCTED

RECIRCULATION FILTER

METAL WIRES

FIG. 6

8. Replace the grid.

FIG. 2

CUT A HOLE IN THE BOTTOM OF

THE CABINET

10-1/4”

19-1/2”

FIG. 3

2