Broan QTRE100S Install Grille Service Parts, Warranty, Finish ceiling, Attach grille to housing

Page 4

 

 

 

MODEL QTRE100S

 

 

 

 

INSTALL GRILLE

 

 

Page 

 

 

SERVICE PARTS

6. Finish ceiling.

Install ceiling material. Cut out around housing.

7. Attach grille to housing.

Squeeze grille springs and insert them into slots on each side of housing.

8.Push grille against ceiling.

WARRANTY

BROAN THREE YEAR LIMITED WARRANTY

Replacement parts can be ordered on our website. Please visit us at www. broan.com

SERVICE NOTE

To remove Blower Assembly: Unplug motor. Remove thumbscrew (12) from motor plate flange. Find the single tab on the motor plate (located next to the receptacle). Push up near motor plate tab while pushing out on side of housing. Or insert a straight- blade screwdriver into slot in housing (next to tab) and twist screwdriver.

Broan warrants to the original consumer purchaser of its products that such products will be free from defects in materials or workmanship for a period of three years from the date of original purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

During this three-year period, Broan will, at its option, repair or replace, without charge, any product or part which is found to be defective under normal use and service.

THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS AND TUBES. This warranty does not cover (a) normal maintenance and service or (b) any products or parts which have been subject to misuse, negligence, accident, improper maintenance or repair (other than by Broan), faulty installation or installation contrary to recommended installation instructions.

The duration of an implied warranty is limited to the three-year period as specified for the express warranty. Some states do not allow limitation on how long an implied warranty lasts, so the above limitation may not apply to you.

BROAN’S OBLIGATION TO REPAIR OR REPLACE, AT BROAN’S OPTION, SHALL BE THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY UNDER THIS WAR- RANTY. BROAN SHALL NOT BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation may not apply to you.

This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. This warranty supersedes all prior warranties.

To qualify for warranty service, you must (a) notify Broan at the address or telephone number stated below, (b) give the model number and part identification and (c) describe the nature of any defect in the product or part. At the time of requesting warranty service, you must present evidence of the original purchase date.

Broan-NuTone LLC Hartford, Wisconsin www.broan.com 800-558-1711

Key No.

Part No.

Description

1

97016466

Housing

2

97016449

Duct Connector - 4”

3

98010102

Wiring Plate

4

99170245

Screw, #8-18 X .375

5

97017085

Wire Panel/Harness Assembly

6

97017999

Motor/Blower Wheel Assembly

7

97017478

Motor Plate & Control Assembly

*

97017998

Blower Assembly

 

 

(includes key nos. 6 & 7)

8

97017420

Grille Assembly

 

 

(includes key nos. 8 & 9)

9

99140199

Grille Spring (2 req’d)

10

97018014

Spacer (2 supplied)

11

QTHB1

Hanger Bar Kit

12

99420665

Thumbscrew, #8-18 x .375

 

 

 

Order service parts by “Part No.” - not by “Key No.”

99044368A

Image 4
Contents Read and Save These Instructions Cleaning & MaintenanceOperation Typical Installations Plan the Installation Install Housing & DuctPlan the wiring 1a.Mount housing to joist or I-joistConnect Wiring Attach damper/ duct connectorInstall Inch round duc Twork Connect electrical wiringInstall Grille Service Parts WarrantyAttach grille to housing Finish ceilingLEA Y Conserve Estas Instrucciones AdvertenciaPrecaución OperaciónInstalaciones Típicas Instale LA Cubierta Y EL ConductoPlanifique la conexión eléctrica 1a.Instale la cubierta en las viguetas o viguetasConexión Eléctrica Instale el conductoRedondo de 10,2 Cm 4 pulg Conecte los cables eléctricosInstale LA Rejilla Piezas DE Repuesto GarantíaTermine el cielo raso Acople la rejilla a la cubierta