Advertencia, Precaución | Broan 679FLT, 680FLT, 678MX instruction

FAN/LIGHT COMBINATION VENTILATORS / VENTILADORES CON LÁMPARA MODELS / MODELOS 678 • 678MX • 679 • 679FLT • 680 • 680FLT

READAND SAVE THESE

INSTRUCTIONS

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

1.Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manu- facturer at the address or telephone number listed in the warranty.

2.Before servicing or cleaning unit, switch power off at servicepanelandlocktheservicedisconnectingmeans to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.

3.Installation work and electrical wiring must be done by a qualified person(s) in accordance with all appli- cable codes and standards, including fire-rated con- struction codes and standards.

4.Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent backdrafting. Follow the heating equipment manufacturer’s guideline and safety standards such as those published by the National Fire ProtectionAssociation (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities.

5.When cutting or drilling into wall or ceiling, damage electrical wiring and other hidden

TYPICAL INSTALLATIONS

POWER CABLE

MOUNTING TABS

CEILING

JOIST

HOUSING

CEILING

MATERIAL GRILLE

HOUSING MOUNTED DIRECTLY TO JOIST 2x6 (or larger) Discharge parallel to joists.

POWER CABLE	ADDITIONAL
MOUNTING	FRAMING	*
TABS		*
2 x 4		2 x 4
CEILING	CEILING
JOIST or	JOIST or
TRUSS	TRUSS
HOUSING

CEILING

MATERIAL GRILLE

HOUSING MOUNTED TO 2x4 TRUSS

Requires additional framing for mounting tabs.

Discharge parallel to joists.

ADDITIONAL

POWER CABLE*

FRAMING

MOUNTING

TABS

		HOUSING
"I"	CEILING	"I"
JOIST	CEILING	JOIST
JOIST	MATERIAL	JOIST
	MATERIAL	GRILLE

HOUSING MOUNTED TO “I” JOIST

Requires additional framing for mounting tabs.

Discharge parallel to joists.

	4" ROUND
POWER CABLE	DUCT
POWER CABLE

6.Ducted fans must always be vented to

7.If this unit is to be installed over a must be marked as appropriate for the be connected to a GFCI (Ground Fault rupter) - protected branch circuit.

8.Never place a switch where it can be reached tub or shower.

9.Fluorescent models only: Do not use a switch to control the light of this unit.

10.This unit must be grounded.

MOUNTING TABS

HOUSING

CEILING		ADDITIONAL	CEILING
MATERIAL	GRILLE	FRAMING*	JOIST

HOUSING MOUNTED TO ADDITIONAL FRAMING

Discharge 900 to joists.

	4" ROUND
POWER CABLE	DUCT
POWER CABLE

CAUTION !

1.For general ventilating use only. exhaust hazardous or explosive vapors.

2.This product is designed for ceiling installation only. This product is designed for installation ceilings up to a 12/12 pitch. Ductwork must point up. DO NOT MOUNT THIS PRODUCT IN A WALL.

3.To avoid motor bearing damage and noisy and/ or unbalanced impellers, keep drywall spray, construction dust, etc. off power unit.

4.Please read specification label on product for further information and requirements.

Installer: Leave this manual with the homeowner.

Homeowner: Use and Care information on page 4.

MOUNTING TABS

HOUSING

2 x 4			ADDITIONAL		2 x 4
2 x 4	CEILING		FRAMING		2 x 4
CEILING	CEILING	GRILLE	FRAMING	*CEILING
CEILING	MATERIAL	GRILLE		*CEILING
JOIST or					JOIST or
TRUSS					TRUSS

HOUSING MOUNTED TO 2x4 TRUSS

Requires additional framing for mounting tabs. 0 to joists.

4" ROUND

POWER CABLE

DUCT

MOUNTING TABS

HOUSING

"I"			ADDITIONAL		"I"
	CEILING		FRAMING	*	JOIST
JOIST		GRILLE
	MATERIAL

HOUSING MOUNTED TO “I” JOIST

Requires additional framing for mounting tabs.

Discharge 900 to joists.

LEAY CONSERVE ESTAS

INSTRUCCIONES

ADVERTENCIA

PARA REDUCIR EL RIESGO DE INCENDIO, DESCAR- GA ELÉCTRICA O LESIONES PERSONALES, OBSER- VE LO SIGUIENTE:

1.Utilice esta unidad solamente de acuerdo con las instrucciones del fabricante. Si tiene preguntas comuníquese con el fabricante a la dirección o al número telefónico que se indica en la garantía.

2.Antes de dar servicio o limpiar la unidad, interrumpa el suministro de energía en el panel de servicio y bloquee los dispositivos de desconexión para evitar la reinstalación ac- cidental de la energía. Cuando no se puedan bloquear los dispositivos de desconexión, fije seguramente en el panel de servicio un medio de advertencia que sea visible, como por ejemplo una etiqueta.

3.Una persona o personas calificadas deben realizar el trabajo de instalación y el cableado eléctrico, de acuerdo con todos los códigos y normas aplicables, inclusive los códigos y normas de construcción para evitar incendios.

4.Se necesita suficiente aire para que se realice la combustión y la descarga de gases adecuadas a través de la chimenea del equipo para quemar combustible a fin de evitar las corrientes de inversión. Observe los lineamientos del fabricante del equipo de calefacción y las normas de seguridad, como por ejemplo las publicadas por laAsociación Nacional de Protección contra Incendios (National Fire Pro- tection Association: NFPA), y la Sociedad Americana de Ingenieros en Calefacción, Refrigeración y Sistemas de Acondicionamiento de Aire (American Society for Heating, Refrigeration and Air Conditioning Engineers: ASHRAE), y los códigos locales.ditioning Engineers (ASHRAE), and the local code authorities.

5.Cuando corte o perfore la pared o el cielo raso, tenga cuidado de no dañar el cableado eléctrico ni otras conexiones de servicios que se encuentren ocultas.

6.Los ventiladores con conductos siempre deben tener salida hacia el exterior.

7.Si se va a instalar esta unidad sobre una tina o ducha, debe marcarse que es apropiada para esta aplicación y conectarse a un GFCI (interruptor accionado por pérdida de conexión a tierra) en un circuito de derivación protegido.

8.Nunca coloque el interruptor en un lugar en donde se pueda alcanzar desde la tina o ducha.

9.Modelos fluorescentes solamente: No emplee un interrupto reductor para controlar la luz de esta unidad.

10.Esta unidad debe conectarse a tierra.

PRECAUCIÓN !

1.Esta unidad debe usarse solamente para ventilación gen- eral. No la utilice para la descarga de materiales ni vapores peligrosos o explosivos.

2.Este producto está diseñado solamente para instalarse en el cielo raso. Este producto está diseñado para instalarse en cielos rasos con una pendiente de hasta 12/12. El sistema de conductos debe apuntar hacia arriba. NO MONTE ESTE PRODUCTO EN LA PARED.

3.Para evitar causar daño a los cojinetes del motor y pistones impulsores ruidosos y/o no balanceados, mantenga los aerosoles para pirca, el polvo de construcción, etc. lejos del motor.

4.Por favor consulte la información y los requerimientos adicionales contenidos en la etiqueta de especificaciones que se encuentra en el producto.

A la persona que realiza la instalación: Deje este manual con el dueño de la casa.

Al dueño de la casa: Las instrucciones de operación y limpieza se encuentran en la página 4.

*Additional framing must be a 2x6 (minimum height), at least 9-inches long.

678MX, 678, 679, 680, 679FLT specifications

The Broan range of vented and non-vented range hoods, including the 679FLT, 680FLT, 678MX, 679, and 680 models, is designed to elevate the cooking experience in any kitchen. These hoods are engineered for performance, efficiency, and style, ensuring that smoke, odors, and grease are effectively removed from the cooking area.

The Broan 679FLT and 680FLT models are known for their valuable combination of functionality and aesthetic appeal. Both units feature a sleek, modern design that fits seamlessly with various kitchen décors. They come equipped with powerful motors that deliver superior ventilation, capable of moving significant amounts of air to keep your kitchen fresh even during the most intense cooking sessions.

In terms of technology, these hoods utilize a two-speed fan, providing flexibility for different cooking needs. The low-speed setting is perfect for simmering and light cooking, while the high-speed setting is ideal for frying or grilling. These models also include a dishwasher-safe aluminum grease filter, which makes maintenance easy and ensures the longevity of the appliance.

The Broan 678MX, meanwhile, is particularly known for its compact design without compromising powerful airflow. This model is perfect for smaller kitchens or spaces where every inch counts. It also features the same two-speed operation, along with advanced airflow options to accommodate a variety of cooking styles.

The traditional Broan 679 and 680 models offer a classic design paired with durable construction. They are built with robust materials that not only resist the typical wear and tear of a busy kitchen but also maintain their aesthetic charm over time. The simple controls make them user-friendly, allowing you to easily switch between speeds.

All these models come equipped with integrated lighting, providing illumination directly over your cooking surface. This feature enhances visibility while cooking, ensuring safety and precision when preparing meals.

In summary, the Broan 679FLT, 680FLT, 678MX, 679, and 680 range hoods collectively represent a perfect balance of modern technology, style, and efficient airflow. With their robust features, they cater to a range of kitchen sizes and designs, making them an excellent choice for both amateur and professional chefs alike. Whether it’s powerful ventilation, easy maintenance, or a sleek look, Broan's range hoods stand out as reliable partners in culinary excellence.