ALLURE® QS2 SERIES
RANGE HOOD
®
Page 4
PREPARE THE HOOD
TOP RECTANGULAR |
| |
DUCT KNOCKOUT | ||
(Remove for 3¼” x 10” | ||
DUCT KNOCKOUT | ||
Vertical & for 7” Round | ||
(Remove for 7” Round | ||
Discharge) | ||
Discharge) | ||
|
REAR
RECTANGULAR
DUCT KNOCKOUT
(Remove for 3¼” x 10” Horizontal Discharge)
11Remove appropriate Duct Knockout(s) from top or back of hood.
PREPARE THE HOOD
TAPE | TOP/BACK |
UP TO 1” | EDGE |
|
|
ADJUSTMENT |
|
➙➙
DAMPER/
PIVOTDUCT CONNECTOR (Vertical discharge position shown)
13 3¼” x 10” Ducted Discharge Only: Remove Tape from |
damper flap and attach Damper/Duct Connector over |
knockout opening with screws removed in Step 4 under |
“PREPARE THE HOOD”. Make sure damper Pivot is nearest |
to Top/Back Edge of hood. |
14 7” Round Ducted Discharge Only: |
Plate removed in Step #1 under “PREPARE THE HOOD”. |
Install a 7” round damper (purchase separately). Damper |
flap must open freely in direction of airflow (away from range |
hood). |
SCREW
TIES
NOTE To accomodate
BLOWER TAB
RETAINING WHEEL RING
SMALL DIAMETER
END
SECTIONS | RING | |
| ||
|
|
|
| MOTOR | STOP |
| SLOTS | EDGE |
METAL STRIP | PLATE |
12Horizontal Discharge Only: Remove the Plate in front of the horizontal discharge knockout. Cut the Ties, lift plate out, and discard plate. DO NOT REMOVE the Metal Strip held in
place with two Screws.
15
To install ring:
1. Remove the Blower Wheel by rocking it side to side and applying a slight force to pull wheel from motor. Remove Retaining Ring if necessary.
2. Slide the ring onto the Small Diameter End of the wheel and down to the Stop Edge of the wheel.
3. Reassemble wheel to motor. Make sure Tab on wheel fits into one of the Motor Slots.
4. Push wheel down until it is locked in place.
5. Check that wheel is properly positioned as shown. Press Sections into place if necessary. Make sure wheel turns freely.