Cannon 10850G, 10855G, 10856G installation instructions Electrical Connection

Page 31

ELECTRICAL CONNECTION

WARNING - THIS APPLIANCE MUST BE EARTHED

Your cooker should have been checked to ensure that the voltage corresponds with your supply voltage, which is stated on the data badge fitted on the rear panel.

The cooker must be connected by a contractor/engineer who is registered with the National Inspection Council for Electrical Installation Contracting (NICEIC), to a suitable double - pole control unit with a minimum rating of 30A and a minimum contact clearance of 3mm, which should be fitted adjacent to (but not above) the cooker, in accordance with IEE regulations.

The power supply cable should conform to BS6004 with a conductor size of 4mm2.

The control unit should be easily accessible in the event of an emergency.

This appliance conforms to EN55014 regarding suppression of radio and television interference.

Access to the mains terminals is gained by removing the rear access cover.

The mains cable must pass through the cable clamp adjacent to the terminal block. Sufficient cable should be used to allow the cooker to be pulled out for servicing.

INSTALLATION & OPERATIONAL CHECKS After installation, check for gas soundness.

Fit the hotplate burner bodies, burner port rings, enamelled discs and pan supports referring to the instructions for use where necessary.

1.Check that the hotplate burners ignite correctly and burn with a steady flame. Check for a steady flame on the low setting.

2.Check that with the left hand oven set at 230˚C, the oven fan operates and the oven heats up.

3.Check that with the right hand oven set at 230˚C, the oven heats up.

4.Check that the twin grill heats up.

5.Check operation of clock.

Instruct the user on the operation of the cooker.

31

Page 30 Page 32
Image 31
Page 30 Page 32
Contents Professional Traditional Contents Introduction Please read the precautions below before using your cooker For Your SafetyFor Your Safety Automatic Cooking Oven Timer OperationGuidance on Automatic Cooking Clockface Setting the Time of DAY Auto Cooking Programmes Oven Timer Operation Other Notes on Timer Operation To USE the Hotplate HotplateHOW to Deal with a FAT Fire Safety Requirements for Deep FAT FryingGrill PAN Handle Twin GrillTo USE the Grill Oven Positions FAN OvenTo Prepare Meat and Poultry for Roasting in Your FAN Oven Temperature and TimeFrozen Meat and Poultry Oven Control Conventional OvenOven Cooking Chart Baking Fan Oven Cooking Conventional Oven Cooking Storage Compartment ‘SLOW COOK’ SettingPreparing Food for Slow Cooking ‘HEAT CLEAN’ Liners Care and CleaningReplacement of Oven Light Bulb Cooker Finish Cleaning Method Something Wrong With Your Cooker Problem CheckSlow Recommended in the Cooking Charts Recommended setting slightly to suit your tasteProgramme or cannot get Timer to turn the ovenTimes Timer display shows ‘000’ Cannot set an ‘Auto Cook’Location Installation InstructionsGAS Safety Installation & USE Regulations Model Numbers 10850G, 10855G, 10856G Category II2H3+ GB. IEGeneral Technical Data DimensionsConversion for USE on Butane or Propane Cooker Hoods Space for FixingLevelling UnpackingStability Chain 450 Electrical Connection Extended Warranties After Sales ServiceRepair Service and Information Help Desk Genuine Parts & Accessories
Top Page Image Contents