Install Vent Hood Into Soffit

Vent Hood Installation (with soffit)

At this point in the installation process, the inner liner should be removed from the Hood and set aside (see-Pgs 5 & 6).With the liner set aside, there is clear access to the Soffit mounting holes and wall mounting holes in the rear panel of the unit.

Once the soffit framing has been completed, place assembled vent hood (hood, rough-in kit, and ventilator) into place and secure hood to the soffit frame with 6 wood screws.

NOTE: Additionally, we recommend the installer utilize the holes provided in the rear panel of the hood to secure the hood to the rear wall and minimize any noise and vibration of the unit.

NOTE: Assure that the mounting screws are long enough to be driven through the wood shims into the installed 2” x 4”s for total support. -see fig.3

-GO TO FINISHING THE INSTALLATION- Pg. 9

FIG.03	TOP VIEW (48" MODEL SHOWN)
		"B"	"B"
		"B"	"B"

2 x 4's installed per Fig. 1

3/8" Soffit mounting holes in Vent Hood (6 total)

Rough-in Kit

(23-1/2 x 10-1/2")

ALL MODELS

12"

25"

FRONT VIEW		2 x 4's in Soffit
FRONT VIEW		Outer 2 x 4's
		Outer 2 x 4's
		(48" Models only)
"A"
	Rough-in Kit	CEILING DRYWALL
	Rough-in Kit

Soffit Mounting Screws (6)