Creda CRC60 manual Wall Fixings, Lower Fixings, Upper Fixing Bracket, Fixing the Canopy Hood

Installing your Cooker Hood

WALL FIXINGS:

Lower Fixings

1.Draw a vertical line on the wall, from the centre of the cooking appliance, up to the ceiling. Check the line is vertical using a spirit level.

2.Put the template provided on the wall and drill two ø12mm holes (Fig.1 2)

3.Fit two hooks in the drilled holes (Fig.1 3).

Upper Fixing Bracket

1.Draw a horizontal line through the vertical line, 15mm from the ceiling. Check the line is level using a spirit level.

2.Place the chimney support bracket (Fig.1 10) over the line, ensuring the bracket is level. Mark the positions for the fixing screws.

3.Drill the two holes for the wall bracket, insert the wall plugs and fit the bracket using the screws provided.

FIXING THE CANOPY HOOD:

1.Remove the metal filters (Fig.1 4).

2.Hang the hood canopy on the hooks (Fig.1 3). Adjust the position of the hood using the two screws at the bottom of the hooks (Fig.1 5).

3.Whilst the hood is positioned, mark the two holes (Fig.1 6).

4.Remove the hood and drill the two holes. Insert the wall plugs (Fig.1 7). Return the hood to the hooks and fix with the two screws.

Before fitting the chimney to the canopy, make the electrical connection as described in the section ‘Electrical Requirements’ (page 2). Once the electrical connection has been established, test the worktop illumination and the three speed fan.

Fig.1

6