English GB

GENERAL

Carefully read the following important information regarding installation safety and maintenance. Keep this information booklet accessible for further reference. The appliance has been designed for use in the ducting version (air exhaust to the outside – Fig.1B), filtering version (air circulation on the inside – Fig.1A) or with external motor (Fig.1C).

SAFETY PRECAUTION

1.Take care when the cooker hood is operating simultaneously with an open fireplace or burner that depend on the air in the environment and use a fuel source other than electrical energy, as the cooker hood removes the air from the environment which a burner or fireplace need for combustion. The negative pressure in the environment must not exceed 4Pa (4x10-5 bar). Provide adequate ventilation in the environment for a safe operation of the cooker hood.Follow the local laws applicable for external air evacuation.

Before connecting the model to the electricity network:

-check the data plate (positioned inside the appliance) to ascertain that the voltage and power correspond to the network and the socket is suitable. If in doubt ask a qualified electrician.

-If the power supply cable is damaged, it must be replaced with another cable or a special assembly, which may be obtained direct from the manufacturer or from the Technical Assistance Centre.

-This device must be connected to the supply network through either a plug fused 3A or hardwired to a 2 phase spur protected by 3A fuse.

2. Warning !

In certain circumstances electrical appliances may be a danger hazard.

A)Do not check the status of the filters while the cooker hood is operating

B)Do not touch bulbs or adjacent areas, during or straight after prolonged use of the appliance.

C)Flambè cooking is prohibited underneath the cooker hood

D)Avoid leaving exposed flames and always ensure that the burners are covered as open flames are damaging for the filters and a fire hazard

E)Constantly check food frying to avoid overheated oil becoming a fire hazard

F)Disconnect the electrical plug prior to any maintenance.

G)This appliance is not intended for use by young children or infirm persons without supervision

H)Young children should be supervised to ensure they do not play with the appliance

I)There shall be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels

L)There is a risk of fire if cleaning is not carried out in accordance with the instructions

This appliance conforms to the European Directive EC/2002/96,

Waste Electrical and Electronic Equipment (WEEE). By making sure that this appliance is disposed of in a suitable manner, the user is helping to prevent potential damage to the environment or to public health.

The symbol on the product or on the accompanying paperwork indicates that the appliance should not be treated as domestic waste, but should be delivered to a suitable electric and electronic appliance recycling collection point. Follow local guidelines when disposing of waste. For more information on the treatment, re-use and recycling of this product, please contact your local authority, domestic waste collection service or the shop where the appliance was purchased.

INSTALLATION INSTRUCTIONS

Assembly and electrical connections must be carried out by specialised personnel.

• Electrical Connection

The appliance has been manufactured as a class II, therefore no earth cable is necessary.

The connection to the mains is carried out as follows: BROWN = L line

BLUE = N neutral

If not provided, connect a plug for the electrical load indicated on the description label. Where a plug is provided, the cooker hood must be installed in order that the plug is easily accessible.

An omnipolar switch with a minimum opening of 3mm between contacts, in line with the electrical load and local standards, must be placed between the appliance and the network in the case of direct connection to the electrical network.

•The minimum distance between the support surfaces of the cooking pots on the cooker top and the lowest part of the cooker hood must be at least 65 cm. If a connection tube composed of two parts is used, the upper part must be placed outside the lower part. Do not connect the cooker hood exhaust to the same conductor used to circulate hot air or for evacuating fumes from other appliances generated by other than an electrical source. Before proceeding with the assembly operations, remove the anti-grease filter(s) (Fig.6) so that the unit is easier to handle.

- In the case of assembly of the appliance in the suction version prepare the hole for evacuation of the air.

•We recommend the use of an air exhaust tube which has the same diameter as the air exhaust outlet hole. If a pipe with a smaller diameter is used, the efficiency of the product may be reduced and its operation may become noisier.

•Warning: if the bulbs are not working, ensure that they are screwed in fully.

•Installation

Prior to proceeding with the assembly operations (according to the model that you have purchased), to facilitate handling of the device, remove the grille as indicated in Fig. 5.

•The appliance is equipped with 2 air outlets, to be used in accordance with your specific requirements: one is located on the upper part of the appliance and the other at the rear (Fig.

- 6 -

HBV60X specifications

The Beko HBV60X is a modern built-in single oven that combines cutting-edge technology with practicality, making it an ideal choice for home cooks and professional chefs alike. This versatile oven offers a variety of features designed to enhance your cooking experience while ensuring consistent and delicious results.

One of the standout features of the Beko HBV60X is its multifunctional cooking capabilities. With multiple cooking modes, including conventional cooking, fan-assisted cooking, grill, and defrost, this oven allows you to prepare a wide variety of dishes. The fan-assisted cooking feature evenly distributes heat throughout the oven cavity, ensuring that food is cooked thoroughly and uniformly, which is perfect for baking.

The HBV60X also comes with an impressive capacity, boasting a spacious interior that accommodates large dishes and multiple trays. This makes it an excellent choice for families or those who love to entertain guests. The oven is designed to maximize cooking efficiency, enabling you to cook several items at once without compromising on quality.

In terms of technology, the Beko HBV60X incorporates a user-friendly digital display and control panel. This intuitive interface simplifies the cooking process, allowing you to select your desired cooking mode and temperature with ease. The oven is also equipped with a timer function, ensuring that your meals are cooked to perfection without the worry of overcooking.

Cleaning is made effortless with the HBV60X, thanks to its easily removable oven door and smooth enamel interior. The enamel coating reduces food residue build-up, meaning less scrubbing and more time to enjoy your meals. Additionally, the oven features a Safety Shut-Off function, providing peace of mind when it comes to energy efficiency and safety in the kitchen.

The design of the Beko HBV60X is sleek and modern, featuring a stainless steel finish that complements a variety of kitchen décors. Its built-in format allows for seamless integration into your cabinetry, adding a touch of elegance to your culinary workspace.

In summary, the Beko HBV60X is a top-of-the-line built-in single oven that combines functionality, advanced technology, and convenience. With its multiple cooking modes, spacious interior, and easy-to-use controls, it is designed to meet the needs of any home chef. Whether you’re baking, roasting, or grilling, the HBV60X ensures that every meal is a delightful experience.