5. Assigning video sources
All of the 540R v3’s rear panel video inputs
Select the ‘Input Assign’ menu. Highlight each Video input in turn and select a source to assign it to:
Input Assign Menu
S/Comp1 : 6.1Direct
S/Comp2 : DVD
Component1 : DVD
Component2 : Video1
HDMI1 : DVD
HDMI2 : Video1
Return to Menu | : [OSD] |
Note: The 540R v3 prevents you from setting two sources to the same video input, as this would cause problems, but doesn’t prevent you from setting the same source to different video inputs.
The 540R v3 has two HMDI (High Definition
The 540R v3 performs HDMI switching, not processing, it routes the HDMI signals from the source equipment to the TV/Monitor without any processing, so as far as the 540R v3 is concerned there is no setup involved other than to assign the three inputs to a desired source. The 540R v3 does not receive audio or video over the HDMI, so for surround- sound decoding etc, an audio connection must also be made from your HDMI source to the 540R v3. As with other sources this can be analog or digital audio. A digital audio SPDIF/Toslink connection is preferred and will be required if it is desired to decode
HDMI sources.
Press the OSD button to exit the menu.
HDMI Pre-Emphasis
The HDMI interface is generally specified for transmission over cable lengths up to 5m. For longer cable runs the 540R v3 is able to apply some
The maximum cable length possible depends on cable quality and to some extent on the resolution of the video being transmitted (i.e. higher bit rate signals are harder to transmit over long distances). HDMI cable repeaters are available from acessory suppliers and may be required for cable lengths >15m.
Select the ‘Output Setup’ menu, highlight ‘HDMI PRE’ and select either ‘Off’ or ‘On’:
Output Setup Menu
Preamp Out | : | Normal |
HDMI PRE | : | On |
Return to Menu | : [OSD] |
Press the OSD button to exit the menu.
azur 540R v3
ENGLISH
15