Zephyr ZMIM90AG Installation - Ductless Recirculating, Fig. C, Fig. B, Hood Model, Filters in Pkg

Page 12
Installation – Ductless Recirculating

Installation – Ductless Recirculating

www.zephyronline.com

Ductless recirculation is intended for applications where an exhaust duct work is not possible to be installed. When converted, the hood functions as a recirculating hood rather than an exhaust hood. Fumes and exhaust from cooking are drawn and filtered by a set of optional charcoal filters. The air is then purified and re- circulated back within the home.

We recommend to ALWAYS exhaust air outside of the home by employing existing or installing new duct work, if possible. The hood is most effective and efficient as an exhaust hood. Only when the exhaust option is not possible should you recourse to converting the hood into a recirculating hood.

When converted to be a recirculating hood, a set of charcoal filters are required on top of its standard Metal Filter set. Order according to its Part number below. The standard Metal Filters are intended to capture residue from cooking and the optional charcoal filters help to purify fumes exhausted from cooking for re- circulation.

RECIRCULATING KIT (REQUIRED IF NO DUCTING IS USED)

Kit includes charcoal filters and air diverter plate.

Hood Model

Part No.

Filters in Pkg.

 

ZMI-M90AG/AS

ZRC-0040

2

 

1.

Purchase recirculating kit per the part number above

 

2.

Secure air diverter plate to wall below duct cover bracket. (FIG. B)

 

 

Run 6” ducting from top of hood and secure to air diverter plate. See

 

 

manual included with recirculating kit for more detailed instructions.

(blower

 

 

 

 

housing)

3.

Remove metal mesh filters from hood. Clip charcoal filters onto each

 

 

charcoal filter bracket. (FIG. C) The brackets are pre-installed and

 

 

located beind the mesh filters.

 

 

4.

Re-Install metal mesh filters.

 

 

FIG. B

 

 

 

 

5. Enable charcoal filter change indicator on control panel. (Refer details to pg. 12)

6.Charcoal filters must be replaced after every 120 hours of use (or approximately every 3 to 4 months based on the average of 1 - 2 hrs. of daily cooking time). The microprocessor in the controls when set, will elapse and count usage time and indicate when charcoal filter replacement is required every 120 hrs.

Charcoal Filter Replacements

Hood Model

Part No.

Qty to Order
ZMI-M90AS/AG
Z0F-C002

2

front of the hood

ERECIRCULATING KIT (REQUIRED IF NO DUCTING IS USED)Hood ModelFilters in Pkg.FIG. BCharcoal Filter Replacements

Qty to OrderZMI-M90AS/AGZ0F-C002FIG. CManual background D

DO NOT WASH CHARCOAL FILTERS. Charcoal filters may need to be changed more often depending on cooking habits.

Charcoal Filter Dimensions: 9in x 6 3/8in

228mm x 162mm

back of the hood

Install charcoal filter (plastic side exposed) into charcoal filter bracket. Insert tab cut-out side D of charcoal filter into bracket first. Lock charcoal filter into place by pushing down on side E with locking tabs.

FIG. C

10

Image 12
Contents Use, Care, and Installation Guide Milano WallZMI-M90AS ZMI-M90AG Page Table of Contents INSTALLATIONFEATURES & CONTROLS MAINTENANCEImportant Safety Notice READ AND SAVE THESE INSTRUCTIONSOPERATION ELECTRICAL REQUIREMENTSList of Materials Ducting, conduit and all installation toolsCable connector if required by local codes Duct cover extension accessory - Z1C-00MIInstallation - Ducting Calculation Sheet Installation - Mounting Height & Clearance DUCTINGMinimum Mounting Height Ducted Maxmimum Mounting HeightInstallation - Ducting OptionsWARNING FIRE HAZARD w/ gravity damperInstallation - Hood Specificationsside of hood 20 1/2”Installation - Mounting the Hood fig. A fig. A2Cable Lock Cable LockInstallation - Ductless Recirculating Charcoal Filter ReplacementsRECIRCULATING KIT REQUIRED IF NO DUCTING IS USED FIG. CFeatures & Controls - Touch Controls Display speed level, delay off, filter clean/changeLights On/Dim/Off Adjust 6 Speed Levels 15 Min Delay Off Metal Filter Clean Reminder metal mesh filterChange Reminder Charcoal FilterFeatures & Controls Charcoal Filter Change Reminder charcoal filter, if installedFilter Clean Reminder Features & Controls - Metal MeshMetal Filter Clean Reminder metal mesh filter Metal Filter Clean IndicatorMaintenance - Hood and Filter Cleaning SURFACE MAINTENANCEMetal Mesh Filter Dimensions Metal Mesh FiltersMaintenance - Lights CAUTION Light bulb becomes extremely hot when turned onREPLACING LIGHT BULBS f theTroubleshooting TROUBLESHOOTING PROCEDURES FOR MILANO WALLIssue CauseList of Parts & Accessories Replacement PartsOptional Accessories DESCRIPTIONLimited Warranty JUN08.0101