Zephyr ZMIM90AG, ZMI-M90AS manual Important Safety Notice, Read And Save These Instructions

Page 4
Important Safety Notice

Important Safety Notice

READ AND SAVE THESE INSTRUCTIONS

www.zephyronline.com

WARNING

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT USE THIS FAN WITH ANY SOLID-STATE CONTROL DEVICE.

WARNING

TO REDUCE THE RISK OF FIRE ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

a.Use this unit only in the manner intended by the manufacturer, if you have questions, contact the manufacturer.

b.Before servicing or cleaning unit, switch power off at service panel and lock panel to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.

CAUTION

For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors. Take care when using cleaning agents or detergents. Suitable for use in household cooking area.

WARNING

TO REDUCE THE RISK OF RANGE TOP GREASE FIRE:

a.Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.

b.Always turn hood ON when cooking at high heat or when flaming food

c.Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or filter.

d.Use proper pan size. Always use cookware appropriate for the size of the surface element.

e.Keep fan, filters and grease laden surfaces clean.

f.Use high setting on hood only when necessary.

g.Don’t leave hood unattended when cooking.

h.Always use cookware and utensils appropriate for the type of and amount of food being prepared.

WARNING

TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP FIRE, OBSERVE THE FOLLOWING:

a.SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT.

b.NEVER PICK UP A FLAMING PAN – You may be burned.

c.DO NOT USE WATER, including wet dishcloths or towels – a violent steam explosion will result.

d.Use an extinguisher ONLY if:

1.You know you have a Class ABC extinguisher, and you already know how to operate it.

2.The fire is small and contained in the area where it started.

3.The fire department is being called.

4.You can fight the fire with your back to an exit

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

a.Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards. Including fire-rated construction.

b.Sufficient air is needed for power combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent back-drafting. Follow the heating equipment manufacturer’s guideline and safety standards such as those published by the National Fire Protection Association (NFPA) and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE) and the local code authorities.

c.When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.

d.Ducted fans must always vent to the outdoors.

e.If this unit is to be installed over a tub or shower, it must be marked as appropriate for the application and be connected to a GFI (Ground Fault Interrupter protected branch circuit).

g.NEVER place a switch where it can be reached from a tub or shower.

h.Make sure the power is off before installing, wiring or maintenancing.

2

Image 4
Contents Milano Wall Use, Care, and Installation GuideZMI-M90AS ZMI-M90AG Page Table of Contents INSTALLATIONFEATURES & CONTROLS MAINTENANCEImportant Safety Notice READ AND SAVE THESE INSTRUCTIONSOPERATION ELECTRICAL REQUIREMENTSList of Materials Ducting, conduit and all installation toolsCable connector if required by local codes Duct cover extension accessory - Z1C-00MIInstallation - Ducting Calculation Sheet Installation - Mounting Height & Clearance DUCTINGMinimum Mounting Height Ducted Maxmimum Mounting HeightInstallation - Ducting OptionsWARNING FIRE HAZARD w/ gravity damperInstallation - Hood Specificationsside of hood 20 1/2”Installation - Mounting the Hood fig. A fig. A2Cable Lock Cable LockInstallation - Ductless Recirculating Charcoal Filter ReplacementsRECIRCULATING KIT REQUIRED IF NO DUCTING IS USED FIG. CFeatures & Controls - Touch Controls Display speed level, delay off, filter clean/changeLights On/Dim/Off Adjust 6 Speed Levels 15 Min Delay Off Metal Filter Clean Reminder metal mesh filterChange Reminder Charcoal FilterFeatures & Controls Charcoal Filter Change Reminder charcoal filter, if installedFilter Clean Reminder Features & Controls - Metal MeshMetal Filter Clean Reminder metal mesh filter Metal Filter Clean IndicatorMaintenance - Hood and Filter Cleaning SURFACE MAINTENANCEMetal Mesh Filter Dimensions Metal Mesh FiltersMaintenance - Lights CAUTION Light bulb becomes extremely hot when turned onREPLACING LIGHT BULBS f theTroubleshooting TROUBLESHOOTING PROCEDURES FOR MILANO WALLIssue CauseList of Parts & Accessories Replacement PartsOptional Accessories DESCRIPTIONLimited Warranty JUN08.0101