Wolf Appliance Company PW302210R dimensions C T I N G C O N S I D E R a T I O N S

Planning Information

Pro Low-Profile Wall Ventilation Hood

M O D E L P W 3 0 2 2 1 0 ( R )

D U C T I N G C O N S I D E R A T I O N S

Wolf Pro low-profile wall hoods are shipped without the blower assembly. Internal, in-line and remote blower assemblies are available.

IMPORTANT NOTE: Install this ventilation hood only with a Wolf blower.

Pro low-profile wall hoods come standard with a horizontal or vertical discharge. No transition is included. Internal blower WBLOWER-50INT comes with a transition. When using an in-line or external blower, use the optional accessory 10" (254) round transition.

The hood will operate most efficiently when ductwork does not exceed 50' (15 m) in length.

Local building codes may require the use of make-up air. Consult your local HVAC professional for specific requirements in your area.

IMPORTANT NOTE: Wolf Pro low-profile wall hoods must be vented to the outside except when used with the accessory recirculating kit with the 600 CFM blower. Use only metal ductwork.

Refer to the illustration below for ducting considerations for Pro low-profile wall hoods.

DUCTWORK INSTALLATION

THROUGH ROOF

ROOF CAP OR REMOTE BLOWER

10" (254) ROUND DUCT

		ACCESSORY TRANSITION
		FOR IN-LINE OR
SOFFIT OR CABINET		REMOTE BLOWER
OR DUCT COVER		173/4"W x 41/4"D TO 10" ROUND
		93/8"H (INCLUDING FLANGES)
		VERTICAL DISCHARGE
10" (254)	WALL HOOD
HEIGHT OF HOOD

22" (559)

DEPTH OF HOOD

30" TO 36"

(762–914)

COUNTERTOP

TO BOTTOM OF

VENTILATION HOOD

Ducting for Pro low-profile wall hoods.

36" (914)

STANDARD

FLOOR TO

COUNTERTOP

HEIGHT

NOTE: 10" (254) ROUND ACCESSORY TRANSITION SHOWN IN VERTICAL DISCHARGE APPLICATION WITH IN-LINE OR REMOTE BLOWER. REFER TO INSTALLATION INSTRUCTIONS FOR HORIZONTAL DISHCARGE.

Dimensions in parentheses are in

millimeters unless otherwise specified. 6