Care and maintenance

09/2008 - 195070641.00

XEROX BUSINESS SERVICES

Switching the appliance off

Disconnect your appliance from the electricity supply before carrying out any work on it.

Cleaning the appliance

Never use steam cleaners or pressure cleaners on the appliance.

•The stainless steel or enamel-coated external parts and the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and neutral soap. Use specialised products for the removal of stubborn stains. After cleaning, rinse well and dry thoroughly. Do not use abrasive powders or corrosive substances.

•The hob grids, burner caps, flame spreader rings and burners may be removed to make cleaning easier; wash them in hot water and non-abrasive detergent, making sure all burnt-on residue is removed before drying them thoroughly.

•Clean the terminal part of the flame failure safety devices* frequently.

•The inside of the oven should ideally be cleaned after each use, while it is still lukewarm. Use hot water and detergent, then rinse well and dry with a soft cloth. Do not use abrasive products.

•Clean the glass part of the oven door using a sponge and a non-abrasive cleaning product, then dry thoroughly with a soft cloth. Do not use rough abrasive material or sharp metal scrapers as these could scratch the surface and cause the glass to crack.

•The accessories can be washed like everyday crockery, and are even dishwasher safe.

Inspecting the oven seals

Check the door seals around the oven regularly. If the seals are damaged, please contact your nearest Authorised After-sales Service Centre. We recommend that the oven is not used until the seals have been replaced.

Replacing the oven light bulb

1.After disconnecting the oven from the electricity mains, remove the glass lid covering

the lamp socket (see figure).

2. Remove the light bulb and replace it with a similar one: voltage 230 V, wattage 25 W, cap E 14.

3.Replace the lid and reconnect the oven to the electricity supply.

Gas tap maintenance

Over time, the taps may become jammed or difficult to turn. If this occurs, the tap must be replaced.

This procedure must be performed by a qualified technician authorised by the manufacturer.

Assistance

Never use the services of an unauthorised technician.

Please have the following information to hand:

•The type of problem encountered.

•The appliance model (Mod.).

•The serial number (S/N).

The latter two pieces of information can be found on the data plate located on the appliance.

*Only available in certain models.