NuTone NS136SS warranty Cleaning & Maintenance, Prepare hood location, Operation, Vertical Ducting

models Ns130Bl • Ns130ss • Ns130WW Ns136Bl • Ns136ss • Ns136WW

cleaning & Maintenance

For performance, appearance, and health reasons, clean filter, fan and grease-laden surfaces. Use only a clean cloth and mild detergent solution on stainless and painted surfaces. Clean all- metal filters in the dishwasher.

The motor is permanently lubricated and never needs oiling. If the motor bearings make excessive or unusual noise, replace the motor with the exact service motor. The impeller should also be replaced.

Use 120 V, 50 W, shielded halogen bulbs - MR16 or PAR16 with GU10 base. Purchase bulbs separately.

tab

Page 

light switch

This 3-position rocker switch turns lights ON and OFF and controls their intensity.

Press left side of rocker (1) to turn lights ON to low intensity. Press right side of rocker (2) to turn lights ON to high intensity. Set rocker to middle position (0) to turn lights OFF.

prepare hood location

ROOF CAP	3¼" X 10" or
	7" ROUND DUCT
	(For vertical
	discharge)

The grease filters, bottom panel, and blower wheel should be cleaned frequently. Use a warm detergent solution. The grease filters and blower wheel are dishwasher safe.

SOFFIT

CABINET

HOOD

24" - 30" ABOVE

COOKING SURFACE

HOUSE WIRING (Top or Back of hood)

WALL CAP

3¼" X 10" DUCT

(For horizontal discharge)

Note: Some minerals, when in contact with dishwasher soap additives, may cause filters to discolor. This discoloration is not covered by the warranty.

To remove blower wheel: Pull wheel straight down and off of motor.

When reinstalling blower wheel, make sure tab on wheel fits into one hole on motor.

operation

Always turn the hood ON before cooking in order to establish an air flow in the kitchen. After turning off the range, let the hood run for a few minutes to clear the air.

Operate the hood as follows:

HC0020

Blower Switch

This 3-position rocker switch turns blower ON and OFF and controls blower speed.

Press left side of rocker (1) to turn blower ON to low speed. Press right side of rocker (2) to turn blower ON to high speed. Set rocker to middle position (0) to turn blower OFF.

1	Determine whether hood will discharge vertically (3¼” x
	10” or 7” Round), or horizontally (3¼” x 10” only). For ver-
	tical or horizontal discharge, run ductwork between the
	hood location and a roof cap or wall cap. For best results,
	use a minimum number of transitons and elbows.
2	Use the proper diagram below, for placement of ductwork
	and electrical cutout in cabinet or wall. For a non-ducted
	installation, DO NOT cut a duct access hole.

*Note the extra wood shim and mounting screw near the cabinet front, 2-3/8” to the right of the cabinet center line.

					3¼” X 10”
HOOD MOUNTING SCREWS (5)					VERTICAL DUCTING
12¼" (30" hood)			12¼" (30" hood)
15¼" (36" hood)			15¼" (36" hood)
CABINET FRONT			23/8"		*
CABINET				107/8"
BOTTOM			5¼"
	5¼"				17/8"	103/4"
4½" ¾"	VERTICAL DUCT
	ACCESS HOLE
					17/8"
WOOD SHIMS					ELECTRICAL
	CENTER				ACCESS HOLE
(recessed-bottom				(in cabinet bottom)
		LINE
cabinets only)