Kobe Range Hoods RA-094, RA9430SQB, RA9436SQB manual Wiring to Power Supply

Page 8

4.Secure and tighten the mounting screws.

CAUTION: MAKE SURE THE HOOD IS SECURE BEFORE RELEASING.

Ductwork Installation

5.Using Reference E from Table 1 and measurements on Page 11, mark the leveling point for duct cover-mounting bracket.

6.Secure the duct cover-mounting bracket to the wall with two screws (not provided). (Figure 6) Make sure all screws are tightened. NOTE: Inner duct cover will cover the duct cover-mounting bracket.

7.Use aluminum or steel pipe (not provided) to connect the plastic exhaust on the hood to the ductwork above. Use duct tape to ensure all joints are secure and air tight as shown in Figure 7.

Figure 5

Figure 6

Wiring to Power Supply

SAFETY WARNING

RISK OF ELECTRICAL SHOCK. THIS RANGE HOOD MUST BE PROPERLY GROUNDED. MAKE SURE THIS IS DONE BY A SPECIALIZED ELECTRICIAN IN ACCORDANCE WITH ALL APPLICABLE NATIONAL AND LOCAL ELECTRICAL CODES. BEFORE CONNECTING WIRES, SWITCH POWER OFF AT SERVICE PANEL AND LOCK SERVICE PANEL TO PREVENT POWER FROM BEING SWITCHED ON ACCIDENTALLY.

.

8.Connect three wires (black, white and green) to house wires and cap with wire connectors. Connect according to color: black to black, white to white, and green to green as shown in Figure 8

9.Test the operation of the hood before performing the next step. Make sure power is supplied to the hood.

Duct Cover Installation

10.Slide inner duct cover up 2 inches before sliding entire duct cover onto the hood. (Figure 9)

11.Align the inner duct cover to the duct cover-mounting bracket. Secure

Figure 7

Figure 8

6

Image 8
Contents Kobe Brand Range Hood Read and Save These Instructions Page Page Components of Package Must keep all material for returns or refundsInstallation Please Read Entire Instructions Before ProceedingPreparation before Installation Important Peel any protective film off the hoodWiring to Power Supply Install Accessories Operation Instructions Turn onPress Light Control button to turn on halogen light Turn OFFMaintenance To Clean Hood SurfaceTo Clean Baffle Filter To Replace Light BulbSpecifications Measurements & Diagrams Parts List Model NO. RA9430SQB RA9436SQBModel NO. RA9430SQB RA9436SQB Circuit Diagram Disclaimer Claims will not be Accepted After the Allocated DaysWarranty Warranty CertificateTWO-YEAR Warranty Service Period ConditionsImplied WARRANTIES/STATE LAW ServiceConsequential Damage Record the Following Information for Your Record Product RegistrationRegister Your Product
Related manuals
Manual 71 pages 10.86 Kb