Installation

PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING

Calculation before Installation

To calculate the length of the installation, please refer to Table 1. (All calcula inches.)

TABLE 1

A = Height of Floor to Ceiling

B = Height of Floor to Counter Top (Standard: 36)

C = Preferred Height of Counter Top to Hood Bottom (Recommended 27 to 30)

D = Height of Hood

E = Height of the Hood Installation [A (B+C)]

F = Height of Duct Cover [E D]

SAFETY WARNING

HOOD MAY HAVE VERY SHARP EDGES; PLEASE WEAR PROTECTIVE GLOVES IF IT IS NECESSARY TO REMOVE ANY PARTS FOR INSTALLING, CLEANING OR SERVICING.

Preparations before Installation

NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE VENT OPENING.

-Decide the location of the venting pipe from the hood to the outside. Refer

-A straight, short venting run will allow the hood to perform more efficientl

-Try to avoid as much transitions, elbows, and long run as possible. This ma the performance of the hood.

-Use duct tape to seal the joints between pipe sections.

-If necessary, prepare back wall frame with cross framing lumber for secure i Using references on Table 1 and measurements on page 12 decide the level of t lumber. Refer to Figure 2.