Kobe Range Hoods CH0042SQB (42"), CH0036SQB (36"), CH0030SQB (30") manual Turn on, Turn OFF

Page 15

OPERATING INSTRUCTIONS

This KOBE hood is equipped with four electronic controls with a 10-second standby startup & 30- second delay shutoff, powerful centrifugal squirrel cage with baffle filters, bright 12-volt 20-watt halogen lights, and heating lamp sockets (lamps not included).

The four electronic controls are Light Control, Speed Control A, Speed Control B and the Power Control (On/Off). Refer to Figure 18.

Figure 18

Light Control

Power Control

Speed Control A

Speed Control B

TURN ON:

Press Power Control (On/Off) button once.

(Note: If any Control button is not pressed within 10 seconds, power will be automatically turned off).

The KOBE hood will start on Low speed. Each press of the Speed Control button will cycle through the various speeds.

Press Speed Control A button to cycle from Low, QuietMode, High, or Medium. Press Speed Control B button to cycle from Low, Medium, High or QuietMode.

(Note: Speed Control A or B will operate both fans. These two speed buttons will allow you to change the speed quicker.)

Press Light Control button to turn halogen light on. The light has three settings: High, Low and Off

Press the back Red button to turn on heating lamp.

(Note: Heating lamps are sold separately. Heating lamps required 120-volt, 175-watt.)

TURN OFF:

Press Power Control (On/Off) button once, panel lights will flash and power will be completely shut off after 3 minutes.

OR

Press Power Control (On/Off) button twice, all power will be shut off immediately.

If only the lights are on, pressing Power Control (On/Off) button once will turn power off after 30 seconds.

12

Image 15
Contents Kobe Brand Range Hood This page Left Purposely Blank Read and Save These Instructions ContentsPage Page Must keep all material for returns or refunds Components of PackageInstallation For Under the CabinetFor Wall Mount with Optional Duct Cover Installation Table of Contents Make Sure Hood is Secure Before Releasing Under the Cabinet InstallationF E T Y W a R N I N G Page Hood Preparation Before Installation Wall Mount InstallationWall Duct Cover Installation Turn OFF Turn onMaintenance To Replace Light Bulb Specifications Measurements & Diagrams For Under T HE Cabinet Page Rear Knockout Holes For Wall Mount with Optional Duct Cover Baffle Filter & Stainless Steel Spacers Parts List Optional Duct Cover Sold Separately Blower Assembly Electrical Assembly Processor Board Circuit Diagram Model NO. CH0030SQB CH0036SQBModel NO. CH0042SQB CH0048SQB Processor BoardClaims will not be Accepted After the Allocated Days DisclaimerConditions WarrantyWarranty Certificate TWO-YEAR Warranty Service PeriodService Consequential DamageImplied WARRANTIES/STATE LAW Record the Following Information for Your Record Product RegistrationThis page Left Purposely Blank VER.070430