Duct Cover Installation

2.Align hood-mounting bracket to the twoFigure 12 screws on the wall and hook hood into place. Tighten screws to secure hood to

the wall.

3.For safety purposes, extra knockout holes on the back of the hood are provided. Knockout the holes. Remove the baffle filters and attach screws to the wall by accessing underneath the hood.

CAUTION: MAKE SURE HOOD IS SUCURE BEFORE RELEASING

Wiring to Power Supply

Figure 13

SAFETY W ARNING

RISK OF ELECTRICAL SHOCK. THIS

RANGE HOOD MUST BE PROPERLY

GROUNDED. MAKE SURE THIS IS DONE

BY SPECIALIZED ELECTRICIAN IN

ACCORDANCE WITH ALL APPLICABLE

NATIONAL AND LOCAL ELECTRICAL

CODES. BEFORE CONNECTING WIRES,

SWITCH POWER OFF AT SERVICE PANEL

AND LOCK SERVICE PANEL TO PREVENT

POWER FROM BEING SWITCHED ON

ACCIDENTALLY.

4.Connect the electrical wires.

-Connect three wires (black, white andFigure 14 green) to house wires and cap with

wire connectors. Connect according

to color: black to black, white to white, and green to green as shown on Figure 12.

-If necessary to hide the electrical wire connections, push wires back into the

wiring box. Access the wire connections underneath the hood. Make sure wires do not slip between motor or any moving parts to prevent any damage.

5.Use aluminum or steel pipe to connect the plastic exhaust on the hood to the ductwork above. Use duct tape to make all joints secure and air tight as shown on Figure 13.

6.To convert ductwork to 7 round, attached 7 round adapter (provided) to the 6 round plastic exhaust..

7.For 48 hood, prepare either separate parallel connection or upside down Y- Connection for proper ductwork installation. Refer to Figure 14.