Under the Cabinet Installation

Figure 2

Preparation before Installation

Figure 1

NOTE: TO AVOID DAMAGE TO YOUR

HOOD, PREVENT DEBRIS FROM

ENTERING THE VENT OPENING.

∙Decide the location of the venting pipe from the hood to the outside. Refer to Figure 1.

∙A straight, short venting run will allow the hood to perform more efficiently.

∙Try to avoid as many transitions, elbows, and long run as possible. This may reduce the performance of the

hood.

∙Temporarily wire the hood to test for proper operation before installing.

∙Important: Peel protective film off the hood (if any).

∙For installing under the cabinet with recessed bottom, attach 4-inch wide wood filler strips (not included) on each side. Refer to Figure 2.

∙Measure and create access opening

for electrical wires and plastic exhaust under the cabinet.

Hood Installation

Figure 3

CAUTION: If required to move the cooking range to install the hood, turn off the power on an electric range at the main

electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS RANGE.

1.Puncture the knockout holes on the hood as shown in Figure 3.

2.Using references on Table 1 and measurements on page 14-15 center the hood in place beneath the cabinet and flush with the front of the cabinet.

3.Draw electrical wires through cabinet

access opening.

Figure 4

4.From the bottom of the hood, place screw (not provided) into the exact center of each knockout hole. Make sure all screws are in place before tightening screwsCAUTION:. MAKE

SURE THE HOOD IS SECURE BEFORE RELEASING .

5.Make sure to leave this manual for the homeowner.